Inspect the wires at the plug connection coming from the upper pressure line going to the compressor. Wiggle the wires and see if it cuts out. Mine was moaning and groaning and would cut out and stay out unless I wiggled the wire at the pressure switch. Replaced the connector plug and the...
ShopDiesel.com - Performance Diesel Parts, Accessories and Exhaust - FORD/DODGE/GM/CHEVY/GMC
You will need the test strips on the right to test the levels in the coolant and add the Motorcraft ( FW-16 or VC-8 )product on the left to stabilize and maintain the proper level in the coolant. How...
Alot of AIS owners have gone with the Fender Sleeve Mod with an improvement in air flow. Also in the front grill area where the AIS Snorkel is make sure there is no rubber flap blocking air flow. By cutting an opening at the grill snorkel opening is another way to improve airflow. It sucks to...
Have you thought about the Foam Fender Sleeve Mod for your AIS?
Click the link below and scroll down to the bottom right.
7.3L Ford Powerstroke Diesel Air Intake Systems
Would it be a fuel related issue? Maybe as simple as the fuel pick up in the tank has become clogged. My work truck had that happen and the ford techs took about 30 days and several attempts of other warranty fix items to correct the problem before they even attempted to look at the tank pickup...
Good choice of gauges. How do you like the Full Sweep Trans. gauge? You will like the Optix Gauges at night. Easy on the eyes. Did you get the wiring kit with the dimmer to each gauge or no dimmer? I do not have the dimmer nor do I see the need. They are wired to the panel dimmer. I keep them on...
You would want the egt probe pre turbo to measure the exhaust gas temperature. Mine is tapped and mounted in the drivers side exhaust manifold. As the exhaust gas is at its hottest temperature and exits the engine through the exhaust manifold you will then get a reading of how hot the egt is. If...
Welcome, jrdrag
When you get a chance fill out your signature and that will let everyone know what type of truck you have and what mods. you have.
Bushwakd
Look here at the top box for filter and OEM lid
http://catalog.powerstrokeshop.com/partlocator/index.cfm?action=AccessoryCatalog&catalogid=3668&siteid=214083&categoryID=73782&subcat1=74560&subcat2=76043
No, either run tank low on fuel and drop the tank or remove the bed of the truck to access. There are some in tank mods. to do while you are in there or just clean or replace the the orifice. Check part availibility first before dropping tank.
On my early 99 work truck ,the same symptoms...
The fuel pickup tube that is located inside the fuel tank has an orifice with screens on it and the screens can be partially clogged and not getting the proper amount of fuel.