Recent content by RipperF350
-
seems like it is losing coolant
yup just had to do headgaskets on my 05- RipperF350
- Post #4
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
HELLP 2005 6.0 Stumbled onto its face and died last night
it was sudden and the loss of power was very fast it went from normal running condition to dead in about 3 minutes missing worse and worse until it finally died Ford had it for 7 days 5 working days- RipperF350
- Post #15
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
HELLP 2005 6.0 Stumbled onto its face and died last night
It was the HPOP replaced under warranty- RipperF350
- Post #13
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
2005 6.0 stumbled on its face and died
I was thinking it was the FICM too it pops the FICM relay every now and then I'm guessing there is a short somewhere either way i got it to the dealer so its there problem now i'll let everyone know what Ford figures out- RipperF350
- Post #9
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
Sluggish shifting & Turbo lag
4 inch exaust will lower your EGT and deffinatly sound good. As for the turbo lag only way to help that is to chip it or get a tunner- RipperF350
- Post #2
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
HELLP 2005 6.0 Stumbled onto its face and died last night
got fuel... at first i though it ran out of fuel so I did them the other day right after it died on me they only had about 12,000 on them fuel was in the fuel filter above the motor when i replaced it. We also checked fuel pressure last night and did diagnostic check with the Solist for the...- RipperF350
- Post #10
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
HELLP 2005 6.0 Stumbled onto its face and died last night
Thanks Thanks for the information, now all I have to do is take out the chip and the exhaust so i don't get the run around at the dealer. Anyone know of any good dealers in my area (GILROY, CA). I wont go back to the Morgan Hill Ford Store ever again they messed up more than they fixed when...- RipperF350
- Post #8
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
2005 6.0 stumbled on its face and died
I don't think its the HPOP any more ok so my buddy brought over his scanner last night and the HPOP was at 580 PSI when cranking even with the batteries running a little low. We did come up with 11 codes P0269 Cyl. 3 Contribution Balance Fault P2290 ICP to low P2291 ICP to low cranking...- RipperF350
- Post #7
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
HELLP 2005 6.0 Stumbled onto its face and died last night
Not the HPOP ok so my buddy brought over his scanner last night and the HPOP was at 580 PSI when cranking even with the batteries running a little low. We did come up with 11 codes P0269 Cyl. 3 Contribution Balance Fault P2290 ICP to low P2291 ICP to low cranking and P0261-P0282...- RipperF350
- Post #6
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
2005 6.0 stumbled on its face and died
no smoke at least none that i noticed been going though some threads may be the HPOP but it started out bad and got progressively worse almost like I drove it into the ground in a matter of minutes. Seems like when the HPOP goes it just dies- RipperF350
- Post #4
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
2005 6.0 stumbled on its face and died
So I want to try and diagnose this myself before I end up having to take off all my mods and take it back to the dealer so if anyone could help that would be greatly appreciated. Last night I was getting onto the freeway and the truck just didn't seem to have all the power it normally does...- RipperF350
- Thread
- Replies: 8
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
HELLP 2005 6.0 Stumbled onto its face and died last night
the engine light never came on I have to wait until Tuesday to check codes my buddie is going to bring his code reader over but his shop is closed for the holiday If it was HPOP would my oil pressure drop I was watching all gauges closely and all had normaly readings. Is there a way to...- RipperF350
- Post #3
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
HELLP 2005 6.0 Stumbled onto its face and died last night
So I want to try and diagnose this myself before I end up having to take off all my mods and take it back to the dealer so if anyone could help that would be greatly appreciated. Last night I was getting onto the freeway and the truck just didn't seem to have all the power it normally does...- RipperF350
- Thread
- Replies: 14
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
HELP Crazy sound like someone is hitting my truck with a Hammer
It was Morgan Hill Ford Store that caused it. I checked my body mounts, the driver side front the one under your feet was at 25lbs the middle one was at 30lbs I tightened both of these to 90lbs because the rest were at 110lbs and the service manual says to put them at 60 lbs. Took her for a test...- RipperF350
- Post #8
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
HELP Crazy sound like someone is hitting my truck with a Hammer
sway bar ? I checked the sway bar end links and the ball joints tonight I checked everything once again with the full weight of the truck and then jacked up the frame and checked everything with the suspension free floating. The sway bar bushings and end links all looked in good condition and...- RipperF350
- Post #5
- Forum: 6.0L PowerStroke Engine & Drivetrain
