thanks for all the warm welcomes. My ITP DP/CDP will be here beginning of next week. Can't wait to see the first upgrade of a bone stock virgin truck get completed!!!
Thanks for all the warm welcomes. Just got the rear-brakes serviced on it. Had some broken hardware and no adjustment. It failed state inspection. 480 later and im stopping on a half-dollar instead of a dime
is there a website for the guy with GTS? I'm assuming its built to order and nothing on surplus? I did alot i/c work on my SVO mustangs and i will buy **** already done before i go thru the drama again.
Ok i'm ordering:
2-pod pillar w/ Boost/Pyro gauges from autometer
3" DP with Cat-delete pipe
intake kit with k&n conical
will do a chip last when all those are installed
Hell no you can't never have enough texans!!! I'm from florida and never going back. Call me a traitor but im on the texan band wagon!
Yes I love this truck to death!!!! Wish i woulda got one sooner. I was too busy living in performance car world
thanks for the input. so far my first experiances here are good. i have alot of turbo/gasoline experiance from my mustang days. some knowledge should be applicable
I'm stationed at Fort Hood. Yes both sides of the truck look equally well. No-dents of damage. Just some brush stratches from many hunting trips. Truck us to pull a Camper to the owners hunting camp.
4:10's would be better huh. the fuel miliage does seem to increase with the higher RPM's on...
I recently purchases 1996 4x4 5spd PSD w/3:55 gears. I dont want something that can run 11's in the 1/4 mile. I just want to increase the efficiency of the truck.
Mods im interested in:
Air Intake
Intercooler
Exhuast
Chip
Thanks. It feels great to be back into a truck again. I'm done with performacne cars... I'm already combing around looking for deals on an intake/DP/ and programmer.
I'm looking to add an intercooler to my 1996 PSD. What is the easiest cheapest route to do it? Will the 99-02 7.3 PSD intercooler and plumbing work on the on the earlier trucks?