need serious help here..

drbalazo · Mar 25, 2008

I have a 2002 F350 7.3 and have a problem with it. It keeps making the "CPS" failure symptoms. It dies when running and won't start for a while (10 - 30 minutes) and then it runs again but dies again. I have changed the CPS sensor 5 times in the past 4 days and it keeps doing the same thing. I have no CEL and I hooked up the scanner and reads nothing and there are no codes saved in the memory either. I tried another PCM and that did not fix the problem. I am running out of ideas here. Any help would be greatly appreciated.

Zookie400 · Mar 26, 2008

sounds a lot to me like a few trucks i have had that had been filled up with gasoline. also sounds like air may be getting into the fuel system possibly via a bad injector. just some thoughts.

stop changing the cps....after the second one you are just wasting money!

did you change out the pcm or the idm? be careful doing that, there may be a short in the harness that caused the 'puter to fry in the first place. you could damage a good one that you are bolting in.

when it dies and wont restart....while you are cranking it over does it smoke out of the tailpipe?

roosterdiesel · Mar 26, 2008

Do any of the faces of the sensor have marks? If yes, you have cam walk.

Have you verified the harness with a DVOM?

drbalazo · Mar 26, 2008

No marks on the CPS at all. I also thought about crank/cam walk and hope that is not the case.

What is a DVOM?

roosterdiesel · Mar 26, 2008

Digital Volt and Ohm meter. You need to find a pin out of the CPS wires and check for continuity.

drbalazo · Mar 26, 2008

Ahh I see. Thank you. Will do that first thing in the morning since I am away from it at the moment.

Mike Cleary · Mar 26, 2008

Can you run the buzz test right after the engine dies? If so, are there any codes?

drbalazo · Mar 26, 2008

I am not familiar with the buzz test. Can you explain how to perform such test?

Mike Cleary · Mar 26, 2008

Do you have a scan tool? If not, you can't perform the test.

drbalazo · Mar 26, 2008

Yes. The scan tool shows no codes.

need serious help here..

drbalazo

Master

Zookie400

I WANNA GO FAST

roosterdiesel

Earl needs B100

drbalazo

Master

roosterdiesel

Earl needs B100

drbalazo

Master

Mike Cleary

SDD Junior Member

drbalazo

Master

Mike Cleary

SDD Junior Member

drbalazo

Master

Members online

Forum statistics

Latest posts