Question What did you do to your truck today?

JLDickmon

ursus combibo
Joined
Jun 22, 2006
Messages
4,173
Reaction score
12
Location
49041
changed the oil, decided I need to rebuild the back half of the rear driveshaft, replaced the left upper tie rod at the pitman arm, and bought a couple of hub seals so I can rebuild the right side axle.. :rant
 

JLDickmon

ursus combibo
Joined
Jun 22, 2006
Messages
4,173
Reaction score
12
Location
49041
rebuilt the right side knuckle..
axle joint was destroyed, needle bearing in the hub exploded, wiped out the stub, wear-ever seal, and unit bearing... took 4 hours to convince it to come apart..
 

jeeps and fords

SDD Junior Member
Joined
Jul 16, 2009
Messages
43
Reaction score
0
Location
Morrisville/NY
In the past two weeks I changed the sway bar bushings, the starter, the rear ujoint, turbo compressor housing, injectors, glow plugs and wiring harness for the glow plugs and injectors... Woo glad that's all done!
 

Roadie

Full Access Member
Joined
Nov 24, 2011
Messages
50
Reaction score
0
Location
Gainesville VA
this weekend, I replaced, the rear brake pads, emergency brake pads, rotors, oil bath seals on axles, and brake backing plates. I still have to adjust the emergency brakes because they don't "hold" the vehicle when engaged. When up on the jack, I had them tightened enough to stop the wheel from spinning when engaged, but take off the jack, and it don't stick. Project for next weekend. any tips appreciated... roadie821 at gmail dot com.
 

Members online

No members online now.

Forum statistics

Threads
30,510
Messages
266,056
Members
14,624
Latest member
Romie64
Top