Search results

  1. drmjf

    Question 6.0 glowplug harness?

    My nephews 05 f250 went to the dealer to check out a check engine light on. They found the following codes: p0261, p0611,& p0674. Has anyone run into this problem?:dunno
  2. drmjf

    One less B-17

    It's to bad it went down. Thank God and the pilot no one was hurt. My buddy flew on that same plane when it was in Oakland/Hayward, CA
  3. drmjf

    What was your very FIRST car?

    My first one was a 59 MGA when I was 15. My Mom was driving it home when the engine failed. I learned a lot replacing that engine. Car was fun but never never a british car again.
  4. drmjf

    Php or bully dog

    I have a PHP tuner, I love it the 80dd added 3 mpg and has great acceleration.
  5. drmjf

    stuck thermostat?

    First, the factory dash gauge is computer controlled then the engine temp get above 160 degrees it show normal temp. Second the temp sender center should not move at all. Replace it.
  6. drmjf

    Fuel leak,top of motor at rear

    I had a 97 before the 99. The fuel pump has a weep hole if the pump diaphragm starts to leak, feel around the pump for fuel. Hope this will help.
  7. drmjf

    Coolant Temp sender/gauge question

    I run with a coolant temperature. My understanding is that the computer sets the gauge reading. I have gone to above 240 degrees and my stock gauge never went above 1/2.
  8. drmjf

    Question Best programmer

    I have a PHP chip with the 65 hp towing and 80 hp daily driver and 1200 rpm calibrations. The 80hp raised my freeway MPG by 3 mpg. I went from 14.5 to 17.5 mpg. It feels like a gas truck when I punch it. Before I bought it I called and talked to, I think it was Cody, about what I needed and what...
  9. drmjf

    Coolant service intervals

    NPG+ coolant I have been using the NPG+ for three years. I like it. It runs at 210 F with ZERO pressure. Smells odd, changes colors after a while to a dark brown, but works great.:thumbs
  10. drmjf

    Question Radio

    Go to the nearest parts store and buy a set of ford radio removal tools. They are specially shaped to remove the radio.
  11. drmjf

    CCV Modification for 7.3L

    There is a "certified diesel tech" that has less between his ears than the guy who certified him. If that's possible
  12. drmjf

    Question What did you do to your truck today?

    Today I installed a HF ham radio, repaired the driving & fog lights so they now work. Changed the oil last week, replaced the air filter and the most important thing installed a PHP 6 position chip. The truck likes it.
  13. drmjf

    Are the Optima's worth it?

    I had optima's in my truck lasted about 3 years. The posts cracked. I went with interstate's.
  14. drmjf

    HUBS...to lock or to unlock?

    I rid of both problems with the hubs. The locking and costly hub bearings. I replaced both with Dynatrac hubs. Dynatrac:sweet
  15. drmjf

    Help Needed Steering Box Jamb Nut

    Adjusting the steering box. Try this method. 1 Jack up the front end until the wheels are just off the ground. 2 start the engine and move the steering wheel from lock to lock. 3 try to loosen the adjusting stud while moving the wheel back and forth. 4 hopefully this will allow the...
  16. drmjf

    coolant question

    There is another way. You can use Evans NPG+. It's not cheap but you never have to replace it. No more SCA's no worries about cavitation. I have been using it for 5 years. I love it. I put electric fans on my truck and had them stop working while in the mountains towing a 10' trailer filled with...
  17. drmjf

    steel horse tail gate box

    Here's a link to the steel horse and an other one. Hope this helps.Tailgate Storage Box :: Trucks&Moore.com
  18. drmjf

    Transfer case not engaging with dash switch

    I would definitely change the hubs. I went with dynatrac-free spin hubs. No more bearing problems and warn hubs. :D
  19. drmjf

    Newbie Questions about TAM chip from cheapassdiesel

    Welcome to SDD.
  20. drmjf

    Power steering hissing

    How's the fluid level? If it's low you have a air in the system. It requires that a vacuum of about 2-3 inches be placed on the power steering pump, to remove the air in the system. You need to let the truck idle while keeping the vacuum. It takes about 5-10 minutes. Hope this helps.
  21. drmjf

    Coming from a GM Bose to the SuperDuty... Disapointing

    I have the pioneer speakers in my truck. They sound good for mids and highs. I have a kicker 10" behind the backseat with a 300 watt amp. Make a very good bass sound.
  22. drmjf

    New Member New to site and first diesel

    Welcome to SDD & Merry Christmas.
  23. drmjf

    New Member New from Mass

    Welcome and Merry Christmas.
  24. drmjf

    Building an intake

    Yes, it's a great update.
  25. drmjf

    Question What did you do to your truck today?

    I just replaced my old ford radio with a Pioneer unit that does everything but navigation. Sounds great.

Members online

No members online now.
Total: 37 (members: 1, guests: 36)

Forum statistics

Threads
30,537
Messages
266,113
Members
14,658
Latest member
NattyGlee22

Latest posts

Top