Search results
-
Vacuum control lines
Well crap! My vacum control lines are starting to dry rot. Anyone know if I can order only the vacum line bundle, with the plugs on it - or if the dealer will only sell the wireing harness (since it is inside it - not an option). What I am referring to are the lines that the heater and A/C...- ranaumo
- Thread
- Replies: 1
- Forum: 94-97 PowerStroke Engine, Drivetrain & Chassis
-
Where to check next
Howdy again.:) My problem is the truck is turning over real slow and not always wanting to start. Here is what I have checked/Done so far: Replaced both batteries with Optima blue Cleaned ground and engine contacts metered the batteries at idle - getting 14.5 volts Checked teh GP...- ranaumo
- Thread
- Replies: 6
- Forum: 94-97 PowerStroke Engine, Drivetrain & Chassis
-
Front Rotors
This will be the third set of lifetime swap front calipers on my truck. Does anyone know where I can find quality calipers where I do not have to worry the guy rebuilding them had a hangover that day? This is really frustrating having to go through this process yet again. The problem is...- ranaumo
- Thread
- Replies: 2
- Forum: 94-97 PowerStroke Engine, Drivetrain & Chassis
-
Fuel level float information
Well, after dropping the rear tank, cleaning it and putting it back in, I was thinking about how awfully small it is and such... I have a friend of mine who is willing to make me a tank out of 12ga steel (not shotshells :D ). I remember discussion a while back about only certain types of...- ranaumo
- Thread
- Replies: 3
- Forum: 94-97 PowerStroke Engine, Drivetrain & Chassis
-
Addendum to Fuel Supply Modifications Wiki
I was driving to work and my truck dies while showing 1/8 tank of fuel. I looked at the fuel regulator and it showed zero psi. It was the rear tank that was giving me grief. I went to the wiki and printed the paperwork to follow as a guide. Hutchinaugusta did a great job on the wiki. My...- ranaumo
- Thread
- Replies: 4
- Forum: 94-97 PowerStroke Engine, Drivetrain & Chassis
-
Ball Joints
Y'all, my truck now has over 150K and the front end has started to shake a lot. I recently packed the bearings and suspect it's the ball joints. How much work is involved with the ball joints, is it something the home guy can do? I do not have a press, or torch to heat the ends up. If...- ranaumo
- Thread
- Replies: 21
- Forum: 94-97 PowerStroke Engine, Drivetrain & Chassis
-
CrankCase Modification
Hi All, I did my mod today and wanted to mention a point of difference. On the 95 PSD's the cast part has a reducer built in. Unless you have the updated air hoses, the 3" metal pipe will not work (that's the bad news). The good news is the fitting that bleeds into the cast part is held...- ranaumo
- Thread
- Replies: 3
- Forum: 94-97 PowerStroke Engine, Drivetrain & Chassis
