Search results

  1. C

    Smoke upon startup

    jrdrag - the bluish white smoke is usually unburned fuel at startup. This is caused by too little heat in the combustion chamber.The glow plug system is designed to provide heat to the combustion chamber but over time and use, the glow plugs and glow plug relay deteriorate and need to be...
  2. C

    wont start hot

    That's awesome Rich. I'm not a professional mechanic, just a doctor and I work on my ranch truck because I enjoy it. I was trying to give the original poster an idea of the amount of time it takes to do the work. I should have qualified it by including the fact that I am not a professional...
  3. C

    Fuel Flow Diagram / Regulator Screen

    What I thought was interesting is that the screen is not blocking fuel flow to the injectors.
  4. C

    Fuel Flow Diagram / Regulator Screen

    Hey guy's, I stumbled upon this fuel flow diagram for our trucks and I have a question. Look at the fuel system schematic on the link. http://www.nav-international.com.br/frame_master.asp?tipo=powerStroke&pg=manual_i/powerStroke/hs.asp According to the diagram, the screen at the fuel...
  5. C

    wont start hot

    You are the man if you can take the fuel filter housing out, clean it, R&R the IPR, reinstall the fuel filter housing with new fuel lines, prime and start the engine in 15 minutes. My hat's off to you. James
  6. C

    wont start hot

    Both of the suggestions above are good and both need to be done based upon the mileage of your truck. What is happening is that the high pressure oil pump cannot build enough pressure to fire the injectors until the oil cools down enough to lower the viscosity. As the oil heats up, it gets...
  7. C

    Oil Galley Plug Leak

    Joe - I don't have any experience at the galley plugs but can lend a hand if you need one. I live in Garland, TX. I also own an engine hoist if you decide to go that direction. Home phone is 972-240-0842. James
  8. C

    Coolant Leak at Tranny

    Thanks for the input guy's. I found the problem. I have a leak at the neck that finally got bad enough that coolant drips down the block, follows the lip of the oil pan back to the tranny inspection cover and drips out. The leak seals itself up with a warm engine so first thing in the morning...
  9. C

    EBPV and plug in heater cord

    The EBPV operation is controled by oil temp and/or water temp and combustion air temp sensors. It definitely helped mine to not function if I plugged it in for a few hours before I started it. It also helps to start the truck and let it idle for a few minutes before you are ready to take off...
  10. C

    Coolant Leak at Tranny

    My truck has developed a small coolant leak at the back of the engine that is dripping from the transmission inspection cover. Is there a freeze plug at the back of the block that could be leaking? Any other ideas? Thanks, James
  11. C

    Engine Misfire at Operating Temp

    Joe - did you get injection circuit faults when you performed a cylinder contribution test? I installed a IDM from my '94 F250 and there was no difference at idle however, I ran the cylinder contribution test twice more and it only faulted cylinder no. 3 this time so you may be on to something...
  12. C

    Engine Misfire at Operating Temp

    This morning it ran better than it has the entire time I've owned it....5 months. It was a cold morning, maybe 28 f and apparently was building a little more injection pressure. I ran a cylinder contribution test and it faulted cylinders 1, 4 and 7. In all of my previous cc tests, it has...
  13. C

    Engine Misfire at Operating Temp

    Mudwhistle, Sounds like you and I have about the same problem. I assumed it was injectors and also assumed that after sending them to Swamp that they would come back "as new", but apparently there is some margin of error possible so I will swap injectors two and three into holes four and...
  14. C

    Engine Misfire at Operating Temp

    Thanks 94! Great suggestion! I'll swap injector holes to see if the faults follow the injectors next weekend. Yes, I did suck out the fuel and oil before installing the new injectors to avoid hydrolock. Now, having said that, apparently someone has previously been in the engine to...
  15. C

    Engine Misfire at Operating Temp

    Hi, my name is James and I'm new to this forum. I've got a problem with my engine that maybe you guys can diagnose. I bought the truck a few months ago and it had a distinct mis most all the way through the RPM range. I've had good luck working on my 94 PSD so I thought I could track...

Members online

No members online now.
Total: 102 (members: 0, guests: 102)

Forum statistics

Threads
30,565
Messages
266,218
Members
14,690
Latest member
Daddydirt79

Latest posts

Top