Search results

  1. L

    Wipers grounding cps???

    Thanks for the replies. To JLDickmon, you are correct as to looking for ground faults, I just didnt say what I meant correctly. As to the alt and batts, output 14.2 Batts are new Interstate mtp-65s. When I get a few minutes I will locate the spot Wingdog mentioned. I will update as I can...
  2. L

    Wipers grounding cps???

    Has anyone else had this problem? When I turn on the windshield wipers the truck a) at idle ...stalls b) at anything over 1000 rpm it gives the cps "hiccup". The farther up (low intermittant to high on) the faster it does it. Now for the fun part... It wont do it everytime. BUT it will only...
  3. L

    Early '99 Exhaust ... Need Help ASAP

    I did the same as orion134, although I did it without help. Still easy. Had to cut the old DP to get it out. As for performance, a cold air intake is a must to gain anything. I noticed a little quicker turbo spool up and "off the line" acceleration. As for noise...turn the radio up a few.
  4. L

    Help <trailer guys>

    Bushpilot, What has worked for me in the past is to put the bulb halfway into the gasket then start at one end (whichever way your lights go, mine are vertical) and press the whole thing together working down (or across) with the last little bit being a "thump" with my hand.
  5. L

    Similar Question to Crumm Plumber?

    If your system is like the ones here, there is a 1/4 inch nipple from the main line that goes to the pressure switch. Usually galvanized. They will rust on the inside and plug up the port on the switch and the gauge. With everything off pull the switch and the nipple off and look.
  6. L

    CPS Intermittent

    I'm Back after a month and change of delivering furiture every day and I have a situation. Right before christmas my truck hiccupped like you shut off the fuel, a few minutes later it did it again and died. SES light came on and edge evolution came up with CPS intermittent( i forgot to write...
  7. L

    Question for the gun guru's

    OK Heres my .02. The 17 HMR is on the 22 MAG case, the M2 on the long rifle case (neither did much for me). After 20 years of working on guns I can say that the AR platform IS more accruate out of the box than the mini 14 (I have both) For what you pay for the mini 14 then you pay someone like...
  8. L

    LSD is disappearing...

    Just got back from a 1500 mile round trip to Angel Fire NM pulling a 20' enclosed trailer. Everything west of San Angelo was ULSD. Couldnt tell a difference power or mileage
  9. L

    I'll be off the forum for awhile.

    condolences My prayers are with you, Richard. Thanks for being here, and I am sorry for your loss.
  10. L

    Outta here for a few days...

    A few more Leineys will make the goat a lost memory...... sorry you had the troubles . But CONGRATS for the kids, if you dont go up against the best , you dont know where you really stand and what to work on. Just my .02 but to put it perspective I missed a college scholarship in swimming by .5...
  11. L

    shift actuator

    Check and see if your brake lights come on when you push the pedal. If not look to see if the fuse is blown. There is a thread on this happening but I dont remember where. I know the brake light switch energizes the lockout. Someone will have more detail I'm sure
  12. L

    EBPV and sensor Q

    And unfortunately, I will be on the road tomorrow,so I will not be able to check responses, until I get back. Maybe late Saturday. Thanks again Bill
  13. L

    EBPV and sensor Q

    After being able to read some codes with the Edge EVO, I continue to get a P0470 exhaust pressure sensor malfunction, just by turning the key on(KOEO). I disconnected the op-rod for the valve and it (the valve) was "sticky" so my question is, If I do the EBPV delete as per the WIKI article, what...
  14. L

    Fuel Pressure Bounce

    Big K Thanks for your reply too. I kinda thought that but my experience goes from all gassers to IDI 6.9 to99 psd. ALL FOMOCO. AM always open to enlightenment
  15. L

    Fuel Pressure Bounce

    95 Stroker, Again Thank you, This is what is great about this site. I hope I can help in the future.
  16. L

    Fuel Pressure Bounce

    Thanks for the info 95 Stroker. Put a second gauge on just to make sure it wasnt the problem, but same deal. Just used a 300 psi instead of a 100psi.
  17. L

    Fuel Pressure Bounce

    just talked to him a bit ago. Gauge was liquid filled(summit racing). After 2 days of driving needle was bent from hitting the stop, so we are getting some over 100psi spikes. My 99 sits rock steady at 72 (after shim) so the fluctuation was surprising to me but I know the regulators are different.
  18. L

    Fuel Pressure Bounce

    Was going to help do a FPR shim on a friends 95PSD and when we put the gauge on to get an initial reading, it was bouncing between 35 and 70 psi. Went ahead and put the Ford kit (as per wiki article) and now it bounces between 45 and 85. I would suspect the pump but the truck runs too good. Any...
  19. L

    HELP!! 7.3 IDI

    If nothing at the injectors look at the lift pump. Had an air leak there on my 86 6.9 once.

Members online

Total: 87 (members: 3, guests: 84)

Forum statistics

Threads
30,565
Messages
266,218
Members
14,690
Latest member
Daddydirt79

Latest posts

Top