Search results

  1. B

    Can't pull codes on 97 F350

    Three meters, from $50 to $250 can't pull a code from my truck even though the check engine light is on. I'm wondering if being a 97 it isn't fully OBDII compliant. One of the meters says there are 124 codes to pull but doesn't pull a single one. Does anyone else have a 97 that they can pull...
  2. B

    Pedal (Throttle) Position Sensor malfunctions

    My Pedal Position Sensor PPS, that is attached to the foot throttle assembly, works for 3-4 months then needs to be replaced. I have to replace it when the truck jerks alot, like it gives it fuel, then stops, then starts giving it fuel again. The fact that it wears a PPS out in 4 months makes me...
  3. B

    Starts very rough then smooths out nicely

    WHEN IT HAPPENS: sometimes in cold weather, but many times in cold weather it does not happen. It just seems to happen when it wants to, not because of any set of confitions. WHAT HAPPENS: The truck will start and run kind of rough, like it is missing 2 cylinders, or very rough, like it is...
  4. B

    Question Stealer want $$$ for ICP connector - where for less?

    Not sure if "Private" means "anyone" can't post here, but I'll give it a try. The dealer wants $73 for the 6" ICP wire connector (3 wires and the connector with clasp) that terminates at the ICP and I find it on line for $78! SUPER DUTY ICP CONNECTOR 97 03 7.3L DIESELand it says Huge...
  5. B

    Pedal Position Sensor wacked up

    Six months ago I was having to push my pedal down further than I had to prevoiusly to get the RPMs to increase. Then when I was pushing the pedal a little bit the engine would jump up and down in RPMs as if was quickly stomping on and letting of the pedal, but if I pressed it down more to...
  6. B

    HPOP oil separate from crankcase oil?

    The oil in the crankcase makes its way up to the HPOP reservoir and is used there to fire off the injectors. So when you change your oil you are refreshing that "Top End Oil" too. However, I have also heard that that is more theory than what actually happens. If the later is true, the "Top End...
  7. B

    Kevlar Busing or Needle Bearing Good or Bad??

    In the past 3 months I have put 2 complete clutch kits with the Kevlar pilot bushing and SM flywheels (replaced the original DM) from South Bend. The first job gave me huge vibrations, the second one leaves me with only bad vibrations mostly at 2400 - 2800 RPM. I just dropped my truck off at...
  8. B

    Question How to remove a read axelshaft

    I am trying to remove the rear axelshaft so I can replace the oil seal on the driver's side. I am following the instructions from in my 97 - 2003 Haynes Ford Pickups and Expedition manual but my differential must be different because the instructions don't get me there. Here is what I...
  9. B

    Question Can't remove rear axelshaft

    I am trying to remove the rear axelshaft so I can replace the oil seal on the driver's side. I am following the instructions from in my 97 - 2003 Haynes Ford Pickups and Expedition manual but my differential must be different because the instructions don't get me there. Here is what I have...
  10. B

    Question Bad Pedal Position Sensor

    I pulled codes on my truck and got the following: -FAILED P0122 A circut low input -FAILED P0221 Pedal Position Sensor Performance Ford says I need a new Pedal Position Sensor - the thing you put your right foot on and the stuff that is connected to it - $441 - dealer only part! My...
  11. B

    Question Check Engine Light, Warm Engine, 1500 + RMP

    Today was the first time I saw the Check Engine light on. It only comes on after the truck is well warmed up and only stays on wnen it is running at 1500 or higher RPMs. I know the Check Engine light can mean about 1000 things, but I would like to start narrowing it down. Are there some...
  12. B

    Question U Joints going bad- what to do

    The mechanic that is doing an insurance replacement of a tie rod, says my driver side U-joint is bad and the passenger side is worse. I know you don't know what "bad" and "worse" mean, but I wonder what others' experiences have been. -Since only 1% of my miles are in 4X4 do I really need to...
  13. B

    Question Manual Transmission Filter

    Does a 97 F350 7.3L 4X4 manual 5 speed transmission have a filter? The filter the auto parts store sold me has a 12 X 16 inch gasket - no gasket that big on the transmission, Thanks, BigRedWeather
  14. B

    What is High Pressure Oil Pressure?

    Can someone explain what HPOP does for my truck? -Which aspects of performance does it effect? -What are signs that the pressure or volume are too high or too low? I have seen several posts about HPOP but can find none here, or on Google that explain it. Thanks, BigRedWeather
  15. B

    Where can I buy a scan tool?

    Where can I buy a scan tool? Anyone have a good recomendation? I have a laptop. Thanks, BigRedWeather
  16. B

    Test for a bad clutch

    Two weeks ago my clutch was "hoppin'" as I call it when I let it out. The clutch did not always smoothly transmit power to the wheels. Know that has stopped. Is there a clear test to tell if a clutch needs to be replaced, or is about to go? Thanks, BigRedWeather
  17. B

    Rough start after new GPR and Oil Temp Sensor

    My truck has started for the past six weeks after 1-2 seconds of cranking in 0 to 40 degrees F weather. About a week ago it began taking 5 - 15 seconds of cranking to start so I replaced the Glow Plug Relay and the Oil Temperature Sensor. It still takes 5 - 15 seconds to start. In fact last...
  18. B

    Where's the Glow Plug Relay?

    Can someone tell me where the glow plug relay is? I don't see it in my manuals. A picture would be great but a good description would be very helpful. Thanks, BigRedWeather
  19. B

    Missing 2 cylinders BEFORE it starts

    Yes, that's what it feels like: Missing 2 cylinders BEFORE it starts. Let me give you the BACKGROUND. We have had temperatures + - 20 F for a month. My truck, first winter I owned it, has started the first try every time, sometimes taking a little longer- a maximum of 10 seconds at 0 F...
  20. B

    Speed shifting

    My left knee has gotten very stiff and sore after an accident and being able to shift up an down through the gears without the clutch would be a big help. I have succeeded at this by timing my accelerating and shifting but I do grind gears a little bit. Can anyone describe how to speed shift...
  21. B

    Hod To Replace My Power Steering Pump

    I have been needing to add a few tablespoons of power steering fluid every couple of weeks and now there is what appears to be power steering fluid on the floor below the pump. Does anyone have instructions for replacing the pump? Thanks, BigRedWeather
  22. B

    Instructions Replace Fan With Electric

    Does anyone have pretty detailed instructions on how to replace the factory fan with an electric fan, including the following points? -How to remove the stock fan (hopefully so it can be replaced should I get into some heavy hauling in the future) -Tips on installing the used fan I get from...
  23. B

    How do I pull a code?

    With a laptop can I pull codes off my truck for less than a $50 outlay, or do I have to take it to a shop. BigRedWeather
  24. B

    Need baffels in a 200 gallon tank on an F350?

    I want to put a 200 gallon tank in the bed of my F350. I will secure it to the bed well. If this tank had 150 gallons of oil in it, would I be safe driving it without baffles in the tank? The truck weighs 8000 pounds, but I don't want the 1200 pounds of oil in the tank slamin' around and...
  25. B

    How to Wire Manual Backup Light Switch

    My backup lights do not come on. All fuses are good and I have changed the bulbs, so I suspect the problem is a bad switch in the transmission. Work around time! Does someone have a picture or a good description of where the wires come off the transmission that control the backup...

Members online

No members online now.
Total: 174 (members: 0, guests: 174)

Forum statistics

Threads
30,517
Messages
266,070
Members
14,629
Latest member
Colvinecoboost14

Latest posts

Top