Recent content by jeffnzoya

  1. jeffnzoya

    Just shut down

    My brother has an 05 Excursion, 6.0 diesel. Yesterday we were on our way back home running on the interstate about 75mph on cruise. As he was comeing up on traffic he pressed the brake to release the cruise and the truck just shut down. We had it carried to the local Ford dealer and was...
  2. jeffnzoya

    Warning light

    Thank's for the info. I will pass it along. Jeff
  3. jeffnzoya

    Warning light

    My brother say's his 05 excursion has a light on in the dash that say's the door is adjar. Also, when he first get's in the truck the interior light stay's on for about 5 minutes. Has anyone had this problem? Thanks Jeff.
  4. jeffnzoya

    New wiring harness for 6.0

    we're gonna give it a try. I'll keep you posted.
  5. jeffnzoya

    New wiring harness for 6.0

    He did have the truck cold balance tested at Pro Diesel. The tech said it all checked out and their were no codes. How hard is this harness to put on. Is it a diy project. They are on ebay for $109.00 does that sound right. If so, I am going to recommend that he purchase one unless you...
  6. jeffnzoya

    New wiring harness for 6.0

    My brother's excursion has a miss at 1200 rpm and up. Has anyone ever replaced the harness on their truck and if so, for what reason and did it help. thanks Jeff.
  7. jeffnzoya

    Stock Excursion 1/4 mile times

    It was awful slow off the line but it felt like it was not pulling all the way through the gear's. It also has a bad miss. He can't be running on more than 7 cyl.
  8. jeffnzoya

    Stock Excursion 1/4 mile times

    I agree. I think the truck is bigtime slow. I would think in the 16's anyway.
  9. jeffnzoya

    Stock Excursion 1/4 mile times

    My brother took his 05 Excursion down the track the other day and it ran 19.3. I told him that seemed big time slow. What's the average time/mph for these trucks.
  10. jeffnzoya

    rough start and running

    Is this a DIY project? My brother has an 05 excursion and it is doing the same thing. He had a ford guy put it on the computer and was told to replace the #2 injector and the FICM, $1,200.00 later, no change it actually may run worse. Also you mentioned that if the HPOP is bad it will...
  11. jeffnzoya

    Bad Miss and power loss

    He went with NAPA fuel filter and he uses only ford motor oil.
  12. jeffnzoya

    Bad Miss and power loss

    My brother has an 05 Excursion with the 6.0 diesel and it had developed a very bad miss. After haveing a Ford tech put the truck on a computer he was told that the #2 injector was bad as well as the fuel injection module. A new module and injector, $950.00 later the truck still misses...
  13. jeffnzoya

    Edge programmer?

    Thank's guy's. I'll pass it on. By the way. Does $400.00 sound about right. Jeff
  14. jeffnzoya

    Edge programmer?

    Yes, he know's the orig. owner. He says it's a edge platnum and it is the top of the line in edge programmers. I also mentioned that he shold try it out prior to purchase. As far as EGT's, he would be ok without the pyro hooked up for a short while would he not. Thank's
  15. jeffnzoya

    Edge programmer?

    My brother has an 05 Excursion and has found a used edge with additude programmer. It's in a box and has several wires and cords that look like they plug into the factory wiring harness. It say's on the back of the little black box, "edge 10002 ver 5.3. The additude monitor is ver 1.29...
See more

Members online

No members online now.
Total: 119 (members: 0, guests: 119)

Forum statistics

Threads
30,516
Messages
266,069
Members
14,627
Latest member
castellscl

Latest posts

Top