lucky_lager
SDD Junior Member
does anyone have a diagram of the crash sensors for the aibags in an 04 6L crewcab SD
crash sensors?
- Thread starter lucky_lager
- Start date
I dont but you may have more issue than just the impact sensors.
the pretensioners could be your problem.
assuming your trying to replace parts after a crash...youll need a
code reader to pin-point which items need replacement.
the pretensioners could be your problem.
assuming your trying to replace parts after a crash...youll need a
code reader to pin-point which items need replacement.
lucky_lager
SDD Junior Member
not trying to replace anything in the system i just didnt want to trip it when pulling the front end off... but i figured with the batts disconected id be alright... thanks
MBRPCrazyford
Eat Some Smoke
yes, with BOTH batteries disconnected, you shouldn't have to worry. But, don't mess with em because if you screw one up and you hook the batteries up, it could set the bags off. Be careful. Good luck
crash sensor, ford put sensor in the cab.
Your crash senor is located on the floor just in front of the heat ducking with a black cover in front of it on top of trans-hump in your cab, You can take any thing of the truck, and you will be ok. if your working under the dash kill the power to the truck.
( this sensor is a spring loaded magnet on a rod, the magnet must move about .750 of an inch be for they will go off .)
thats all they use now. we no longer have to deal with sensors all over the place.
Your crash senor is located on the floor just in front of the heat ducking with a black cover in front of it on top of trans-hump in your cab, You can take any thing of the truck, and you will be ok. if your working under the dash kill the power to the truck.
( this sensor is a spring loaded magnet on a rod, the magnet must move about .750 of an inch be for they will go off .)
thats all they use now. we no longer have to deal with sensors all over the place.
Last edited:
lucky_lager
SDD Junior Member
perfect.. thanks for the info guys
