You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Recent content by BDJack
-
B
Missing/no power
My issues were a number of things. Fuel Pump on its way out, caused #1 and #3 injector to fail. That and a ****ty cps that I bought from autozone (it was the type that was recalled) The pump and the injectors fixed my situation. The International cps (24.00) made it stop acting up when it...- BDJack
- Post #95
- Forum: 911 Diesel Down! (Post only if your rig is broke)
-
B
Valve Cover Removal
Bring it to va, i will help for free* *=(pizza&beer):D- BDJack
- Post #21
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
B
Idm
Damn that is pretty generous of you! If you still felt like doing that, we could get it put up on the wiki to help out everyone!- BDJack
- Post #5
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
B
Injectors go bad for the third time!!!!
Have you been replacing them with new or rebuilt injectors? Ford will give you rebuilt ones unless you throw a fit. and pay extra:D I have heard wonderful things about Industrial Injection. Talked to several distributors, and they said not one of them that they knew of had come back for any...- BDJack
- Post #6
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
B
Valve Cover Removal
Passenger side Honestly, I did the pass side today, and it wasnt a big deal at all. If you dont got one, one of those two step stools will make it way easier. Other than that, take off the intercooler pipe, then take the two heater hose holders off their studs by rotating them, then zip tie...- BDJack
- Post #18
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
B
Missing/no power
Update!! Good call JLDickmon! Baby has arrived- all ten fingers and toes of poopy screamy fun! Was not the IDM. Used the test module, no change. Put IDM back in, reassembled fender. Used a really fancy code reader from my buddy at international, and it said #1and #3 injector were bad...- BDJack
- Post #85
- Forum: 911 Diesel Down! (Post only if your rig is broke)
-
B
Missing/no power
Haha, fair enough! Outside temp during the day- High is 40's/Low is 20's Builds sufficent oil psi (more than 500) Voltage around 12.5-13 Has fuel psi (sorry no reading) Glow Plug resistance all around 1.5 ohms GPR reads proper voltage (now) Connections all cleaned, drop tested...- BDJack
- Post #81
- Forum: 911 Diesel Down! (Post only if your rig is broke)
-
B
Missing/no power
We did, but i also saw on the ford tech manual, that it only "needs" 11 volts to start. Thanks for coming back though, help is always welcome... Still waiting on that test module...- BDJack
- Post #79
- Forum: 911 Diesel Down! (Post only if your rig is broke)
-
B
Missing/no power
HAHA, you are kidding right? This thread is 75+ posts long for a reason. Those have already been eliminated, with help from you, Big Joe, and DaveBen! Thanks Again!:cool: That $$$$ is why I am waiting a couple days for a known good one to check before I buy one:D Also that is the code(s) the...- BDJack
- Post #77
- Forum: 911 Diesel Down! (Post only if your rig is broke)
-
B
Missing/no power
Looks like it may be the idm...swapping in a known good one and we will see what happens.......- BDJack
- Post #75
- Forum: 911 Diesel Down! (Post only if your rig is broke)
-
B
Missing/no power
yeah, sure does!- BDJack
- Post #74
- Forum: 911 Diesel Down! (Post only if your rig is broke)
-
B
Missing/no power
So this really sucks. I have had zero luck. Refilled HPOP, IPR tested well, still no start. Getting a code reader on it tomorrow. At a loss.:dunno- BDJack
- Post #72
- Forum: 911 Diesel Down! (Post only if your rig is broke)
-
B
Missing/no power
Yeah I handled the drop tests JL, after some searching:cool: Took out the ipr, cleaned it up, and checked resistance of coil. One of the O-Rings was leaking a bit, and the oil in my HPOP seemed a bit low, which may be the problem, or may be indicative of one of the injector O-Rings leaking...- BDJack
- Post #71
- Forum: 911 Diesel Down! (Post only if your rig is broke)
-
B
Missing/no power
read on here somewhere that icp sensor may be cause...I disconnected it, thread stated that the computer will find other ways to read icp if you disconnect it, no luck there either. IPR is where I am putting my money. Went to Stealership and talked to their diesel tech, and he came to same...- BDJack
- Post #55
- Forum: 911 Diesel Down! (Post only if your rig is broke)