Bought a 2006 Ford F350 recently and it had a gooseneck hitch already installed....however, whoever installed it did not move the exhaust to clear it.....It rubs and vibrates badly....is there a kit out there or relocate the exhaust so that it doesn't touch the hitch?
Mine doesn't have vacuum actuators at the hubs....only a vent tube for the bearing assembly.... I'm pretty sure they are manual....I noticed that the manual hubs are more expensive....sounds like my luck
updated my sig....I'm a first timer on this forum, so work with me:innocent
It is a 2000 f350 dually....it has a switch on the dash to engage the 4wd, but no vacuum lines to the hub assembly....the ones advertised show manual and auto available, but the look the same in the pics.
I have a question for the pros....I have a 2000 Ford f350 crewcab dually 4wd.....having to replace the locking hubs because the existing ones will not disengage when rotating the lock on the hub.....looking at replacements and some are for manual and some are for auto....I have a switch on the...
Mine is a 2000 7.3L.....which DP Tuner did you get?
Also.....I have a stand alone Trans Command from Banks....will there be a conflict with the two together?
everythings good on the wheel/bearing assembly.....there isn't a retaining nut....this is a sealed assembly that attaches by 4 bolts on the back of the knuckle
tried backing up....that doesn't help....the T-case is operating ok.....the only way I can get them to unlock is by jacking up the front end and messing with the axle shaft and rotating the wheel back and forth
I recently replaced the bearing assemblies on the front of my 4WD dually....now having problems with the locking hubs....they lock in ok, but when I unlock them, the front drive train stays locked....won't disengage....can anyone offer some advice on what to do?
Like the Dogman says....the switch is now in the door latch....I had the same problem....it's hard to get to and I can't find any replacements....I took mine apart and cleaned the switch real good and lubricated it....it did the trick....haven't had any probs with it since
Looking at programmers for a mod......I like the Edge Evo because of the display with lots of options....looks like prices are between $500 and $600....has anyone had any good or bad things to say about it?...what r everyones thoughts on the Edge?