Problem solved. Plugged programmer into a friends truck. Same error code. Bad programmer. Exchanged and new one works great. Thanks for all your responses and suggestions. Mike
Its a brand new edge, I spoke to them again today and they said to try putting a battery charger on and close doors, interior lights, no radio, etc... and try agian. They said that even very small fluctuations in voltage may cause this. As far as install goes, just plugged it in- the edge...
Attempted to install and got error code 14, Edge says that it cannot communicate with PCM. Cigar fuse ok. Looked for aftermarket chip that may have been installed- no chip. Truck runs fine, any way to check PCM other than dealership? Use is mainly traveling to construction jobsites and 2000#...
Thanks for the input. The full rebuild is $2000, which includes torque converter, all the soft parts and any valves or "anything" necessary. The SS on the rear end did not affect anything. I have also shot an email to BTS for comparison sake. The current ability of the stock transmission was...
Flow test ok
Flow test 1/2 quart in less than 15 seconds after cooler. No apparent obstructions. Took it to shop-- still no codes. Getting quoted $1300 best case scenario to $1900 for full rebuild at American Transmission here in Jacksonville. Took a tour of the facility, spotless and very...
update
Hit the pedal hard and it shifts thru all gears ok. 1st to 2nd happens alot higher rpm though, about 3200. But it does shift normally thru all gears. Thoughts?
It hits high rpms pretty quick from a start so I haven't gotten on it . Tomorrow I'll hit it hard a few times and see if it makes a difference. Thanks again
Appreciate all the advice. My wife and I bought our 7.3 for a truck camper. Tents were getting too difficult to get in and out of, not to mention the lack of facilities. We are very pleased with our truck, but since I am new to PSD, the more information I can gather from helpful people, the...
Thanks for your information. Are there any external electronic or mechanical controls that I could check prior to going to a transmission shop? New fluid about 5K miles ago.