Recent content by T VALK
-
T
Low fuel pressure
Guage is under hood for now.I will try to purge at guage. Thanks.- T VALK
- Post #8
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
T
Low fuel pressure
Just changed fuel filter and took QD off fuel pump feed.Did not bleed.Went round block pressure still same.- T VALK
- Post #6
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
T
Low fuel pressure
Starts fine and runs okay idles little rough.Guage on rear of fuel filter housing.- T VALK
- Post #4
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
T
Low fuel pressure
Just installed fuel pressure guage only have 25 PSI .Should I start shimming FPR or something else wrong?- T VALK
- Thread
- Replies: 7
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
T
edge evolution
I have a edge Evo and run it on race setting all the time even when towing my trailer 12k lb .Egt never over 800.- T VALK
- Post #5
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
T
Question Tire pressure
Depends on how many ply tire you have should tell you on the side wall the max psi and go from there.- T VALK
- Post #3
- Forum: General Super Duty Discussion
-
T
Calling it a day
Overnite it cheeper than driven.- T VALK
- Post #17
- Forum: 7.3L PowerStroke Power & Performance
-
T
Painting Front Bumper?
You dont have to blast chrome off bumper just have it roughed up by the blaster or you will have a mess . Buy a painted grille chrome ones dont blast well.- T VALK
- Post #6
- Forum: Paint, Body & Interior Care
-
T
Gotta get me some tools
Snap on tools are well worth the money for hand tools pawn shops are full of them around here or e-bay.- T VALK
- Post #4
- Forum: SuperDuty Community Lounge
-
T
edge evolution with monitor are they and good
I have a evolution no problems like the power . I also have juice with att. not impressed with the power out of it .- T VALK
- Post #2
- Forum: 7.3L PowerStroke Power & Performance
-
T
Trouble geting started
I was getting fuel in my coolant tank. With help from this site found cracked sleeves .When i pulled inj. also found bad orings .Runs great what a job to do with heads in the truck.- T VALK
- Post #10
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
T
Trouble geting started
Got it running .This sucks there is no way to bleed these things .Drove it for about 25 miles before it cleared up. Thank you for all the help.- T VALK
- Post #7
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
T
Trouble geting started
No oil in cyl. I pulled idm and cranked it. Its trying to catch but wont. Just keep on cranking?- T VALK
- Post #4
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
T
Trouble geting started
Installed new inj. sleeves and inj. o rings . Having trouble starting truck now . What to do now? Any sug. Thanks- T VALK
- Thread
- Replies: 10
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
