Install the kit. Drill the holes in the plate on the small side. Test drive it. If you like it leave it. If the shifts need improvement. Drill the holes bigger, but not to big.;tu
The Trans Go Tugger kit will have parts for the valve body and accumulator body. plus it will have parts for the pump and a couple of snap rings to replace the factory parts.
FTVB. This is just the accumulator body. Nothing wrong with it. Less work, easy to install. Remove old body. install...
Sounds crunchy. :eek:
You get the honors to pull the tranny again. After this you will be able to pull a tranny with your eyes closed.;tu
Did you check the flex plate for cracks? You will get the same funky sounds with a broken flex plate.
You need a transmission pressure gauge. You will need the adapter that will fit the E4OD/4R100 test port. The test port is located on the drivers side of the tranny. Just above the pan. Most people use this port for the tranny temp gauge.
To test. Install the adapter, hook up the tranny...
The VSS on the rear axle reads the speed and ABS. Turbine speed sensor and Out shaft speed sensor are for the tranny. Output shaft speed sensor is the one located at the rear of the tranny. Or the transfer case adaptor for 4X4.