black_cloud_stroker00
GO BIG RED!!!
in the CCV mod, what is the 4"od x 3-1/2" long steel tube for?
CCV Mod
- Thread starter black_cloud_stroker00
- Start date
black_cloud_stroker00
GO BIG RED!!!
nevermind, i'm freaking blind.
where would you find one of those
where would you find one of those
Replaces the factory coupling tube that has the intake port for the CCV coming from the engine.
You no longer use that port so it needs to be sealed or the coupling replaced........ie the 4"OD X 3-1/2" steel tube.
See the following wiki article.
TikiWiki : CCV Modification for 7.3L
Tbar
CHPMustang
Senior Member
4" diameter steel tubing could be found at exhaust shops & truck shops that do exhaust systems as they may have so scrap leavins.
platinum01
Full Access Member
With you guys doing this mod do you see any oil on your driveway or were do ya'll have it draining to? When I pull the tubes off for the last time I am going to have them Powder Coated and want to do the CCV mod at the same time.
platinum01
Full Access Member
Good to hear. Did you notice how much oil was left in your boots before you did this mod? I get quite abit of oil that I why I was wondering if you get any oil in the drive way.
black_cloud_stroker00
GO BIG RED!!!
can it be sealed with a plug or does it have to be some kind of gel sealant
CHPMustang
Senior Member
The CCV outlet usually leaves maybe a drip every few days.
It's not whats in the boots it's what's in the intercooler
It's not whats in the boots it's what's in the intercooler
black_cloud_stroker00
GO BIG RED!!!
can you just use a PVC cap to plug the intake tract?
