Hard starting after injector change

BIG JOE

Full Access Member
Joined
Apr 6, 2005
Messages
5,423
Reaction score
55
Location
CenCal
16 oz. of 2 cycle oil, to 16 gallons (halfa tank) of diesel could help too.

Joe
 

bigrigr

Real trks hv 3 pdls
Joined
Dec 1, 2008
Messages
372
Reaction score
0
Location
provo, utah
X2 Big Joe, The 2 cycle oil is the cheapest route to gain lubricity back in the fuel, which will quiet down the motor considerably. JMO
 

BIG JOE

Full Access Member
Joined
Apr 6, 2005
Messages
5,423
Reaction score
55
Location
CenCal
X2 Big Joe, The 2 cycle oil is the cheapest route to gain lubricity back in the fuel, which will quiet down the motor considerably. JMO

;tu

I use it religiously. Now'n then I'll top off without adding any... just to thin it out some.. so i'm not outa cal.. on the ratio.. sure can tell the dif, in the way my 7.3 runs & sounds without it.

Good Stuff.

Joe
 

skertin3rd

SDD Junior Member
Joined
Dec 7, 2009
Messages
17
Reaction score
0
Location
Discovery Bay CA
Yeah, you have to run it at or above 2000 rpm for about 30 min as soon as you get it in. Also remember you installed only 1 injector, that means that cylinder is in prime working condition and the other 7 are probably gummed up and not as efficient as the newer one. Did you remove the drain plugs from the heads before installing the new injector?
 

Members online

No members online now.

Forum statistics

Threads
30,517
Messages
266,071
Members
14,629
Latest member
Colvinecoboost14
Top