Crumm
Fordoholic
On the 7.3 that would be the tube that runs up to the exhaust back pressure sensor. I have no idea if the 6.0 has a backpressure sensor but it looks like it does..
Loose Connection on my 6.0 (what does it do)?
- Thread starter BamaSixGun
- Start date
On the 7.3 that would be the tube that runs up to the exhaust back pressure sensor. I have no idea if the 6.0 has a backpressure sensor but it looks like it does..
DA-HEAT
The First Stroker
Yes basically same as 7.3 it is your exhaust backpressure sensor, what it does is measure what kind of ebp is being put out by engine and inputs that into pcm and pcm uses it to adjust the vanes in turbo for optimum performance and efficiency.
no-red 6 0
Senioritis
silly rabbit-
that is where the blinker fluid goes..
just fill it up and your mileage will increase.
that is where the blinker fluid goes..
just fill it up and your mileage will increase.
BamaSixGun
SDD Super Mod/Staff
Thanks Crumm & DA-HEAT.
red, you're just no help at all.
I always check the blinker fluid
red, you're just no help at all.
I always check the blinker fluid
hpprose
Sponsor
Yeah, that's the Exhaust Backpressure tube that runs to the EBP Sensor. If that's not getting the right back pressure, your mpg will be crap!
no-red 6 0
Senioritis
food for thought here....
i perhaps should check MY connector...
but i doubt that is the cause....
i perhaps should check MY connector...
but i doubt that is the cause....
Looks like EBPV tube going to sensor, Bama. I just saw your trashed turbo so it took me a while to get here. Man, when it rains, it pours in Alabama. Sorry for your string of luck that could turn goat p**s into gasoline. Hope you get it sorted.