Recent content by LeeParsons

  1. LeeParsons

    Electric fan conversion

    Anyone have a link to someplace online that sells electric fan conversions for these trucks? Thanks, Lee
  2. LeeParsons

    6 speed and tranny cooler

    roosterdiesel, 80% or my driving is towing anywhere from 8 to 15K lbs. No temp guage yet (it's in the tool box). I run the Rockies and the Southwest desert a lot and don't want any problems in the summer months.
  3. LeeParsons

    6 speed and tranny cooler

    Are any of you guys runing a larger tranny cooler on the ZF6? If so, did you leave the factory cooler and ust put the bigger one in line with it? Any problems or concerns? Thanks, Lee
  4. LeeParsons

    Electric Brakes

    Not sure where it will be on your truck but on my '99 F350 the plug is under the dash sort of behind the A/C controls and cubby. On my '96's it was up behind the radio, but you should have a plug under there someplace.
  5. LeeParsons

    99 6 speed noise

    Dave, how many miles on the truck, clutch etc.? One of the problems with the 6 speed in the '99 is the pilot bearing. I have heard several people tell about the pilot bearing failing and causing damage to the transmission. I myself just went through this, the pilot bearing failed, the input...
  6. LeeParsons

    Dead 6 speed update

    Well, they got everything apart on my truck and found the input shaft and main gear cluster are shot. What happened is tht the clutch I put in itin December broke. The clutch plate broke by one of the springs and caused the input shaft to vibrate and wobble, that in turn killed the pilot bearing...
  7. LeeParsons

    Tranny difference diesel and gas

    Is there a difference in the 6 speed (ZF6) transmission for the gas rigs and diesel rigs? Reason I ask, tranny shop quoted me $1500.00 to rebuild the tranny then called back and said it will be $2100.00 becuase it is a diesel. Are the parts different for the diesel trans or is it another case of...
  8. LeeParsons

    Straight scoop on oil for 7.3

    Ford and all thequick lube places told me my early '99 takes 15 quarts but 14 puts it right on the full mark, 15 shows over full.
  9. LeeParsons

    6 speed going south

    My 6 speed in my '99 F350 is going out, it need syncros and bearings. Anyone know of a REASONABLE rebuild shop in the Dallas area or a place to get the parts at a reasonable price. Ford wants $1,000.00 for the syncros and bearings. Thanks, Lee
  10. LeeParsons

    Adding 2nd fuel tank

    I saw a hookup at Northern Tool and Equipment that connects into the stock tanks vent line (I think) and gravity feeds from the aux tank. From what I read it keeps the stock tank full until the aux tank is empty. I haven't had any experience with it, just read about it.
  11. LeeParsons

    LOST ALL POWER THEN DIED...WONT START,NEED HELP!!

    Could be a bad injector too, I had a '96 that did that and it was an injector gushing oil and not letting the HP oil pump up.
  12. LeeParsons

    Anyone here from Tacoma area

    Just wondering if anyone here was from the Tacoma area? I am on my way there to deliver a travel trailer and thought it might be nice to meet a fellow PSD owner and chew the fat.
  13. LeeParsons

    Newbie here, need opinions on my engine troubles

    Welcome Capricious, Your SMCT 1700 should read the codes, Mine does. From what you have described I would be looking really close at the fuel system. I ran mine out of fuel a few months ago and it took about 100 miles and 2 fuel filters to get the old girl runing right again. Once air is...
  14. LeeParsons

    Ball joints....

    I've never heard of tightening ball joints to take out slack. The ball and socket themselves are what get slack in them, not the bolt and nut that hold them in place. I just replaced both sides on my '99, $58.00 per side for greaseable Moog joints for O'Reily's.
  15. LeeParsons

    Need turbo rebuild kit

    Anyone know of a good place to get a rebuild kit for my turbo? It's and early '99 (build date 11/98) if that matters.

Members online

No members online now.

Forum statistics

Threads
30,517
Messages
266,071
Members
14,629
Latest member
Colvinecoboost14
Top