That I don't. I would check with some of the truck supply stores like Keller truck etc. They might be able to do it or find someone who does. I welded my own exhaust using various bends and straight 4" exhaust pipes from Northern Virginia Supply in Rockville.
-Z
The stacks are going to be louder because they will be exiting pretty much at ear level behind the cab. I wouldn't do stacks on mine only because every 3rd diesel I see has stacks. If you want to change it, do a dual exit behind either rear tire (my opinion only), if I had the dough I would do a...
just found out that one wire in the harness going to the trans is not receiving all 12 volts (4.8 I believe). This caused my trans to go into limp mode. The mechanic ran a new wire and tied it into the harness and it runs fine. Now I am just waiting to get it back because it needs a CPS...
its got approximately 40K on it. I will be getting fluid and filter tomorrow so when I swap it out I will give you guys an update.
Thanks for the help,
-Zach
Ok yall here is my situation,
When I started my truck this morning, I went to pull up my driveway and it didn't move. I put it in drive and it took almost 3/4 pedal to get it to lurch forward. Reverse works fine. OD light flashes on and off on gear shift. No CEL lights. I pulled it into my...
I had a 7.3 idi back in the day. Before I bought it the previous owner used it to pull large woodsplitters and stuff like that. The heaviest I ever towed with it was a Chevy 3/4 ton gas truck pulling the other way:innocent
-Z
I put a new starter in my truck and new solenoid. My issue is when I try to hook up the batteries I get an arc from the battery to the cable and a clicking noise from under the hood. My question is do I have the solenoid wired correctly or is it wrong.
I have the two reds on one of the...
The solenoid wires are so hardened they only go one way. If I am correct the 3 negative (green or grey) wires go on the large post closest to the front of the truck while the two red (one small and one large) go on the other large post with the little wire that fits over one of the small studs.
Here's the situation. Went to start the truck this afternoon (after driving all morning w/ out problem). I turn the key and get a loud click under the hood. No crank at all. So I get a new starter solenoid (passenger side fender well). I connect everything on the solenoid. thats fine. when I go...