Recent content by MudHog
-
M
Who all tows a boat with there PowerStroke
Pro-Drive is to expensive, but a damn good setup for a larger boat. My 14' flat would be good for a Pro-Drive, but I'm not going to spend $5000+ for a outboard motor like that. Pro-Drive is built 20 minutes from my house. Have talked to the guy before too. I'm looking at the go-devil style...- MudHog
- Post #53
- Forum: SuperDuty Community Lounge
-
M
Who all tows a boat with there PowerStroke
Motor got burnt up on a mud flat. Went to the mechanic and put in a nice oversized piston and a little extra compression. Oil injection has been unplugged and running premix fuel straight in the tank. Let's just say that I cam trim up and get the 16' semi-vee out the water on a holeshot...- MudHog
- Post #50
- Forum: SuperDuty Community Lounge
-
M
Who all tows a boat with there PowerStroke
I pull the following (at different times) 1. FishMaster 1960 - 19' fiberglass bayboat with a 130 Johnson Ocean Pro 2. Homemade 14' Flat - 14' aluminum flat btm. duck boat with a 50HP Mercury 3. Homemade 16' Vee - 16' Freshwater aluminum fishing boat with a mod'd 115 Evinrude 4. Thunderbird...- MudHog
- Post #45
- Forum: SuperDuty Community Lounge
-
M
Dog pictures
My turn........ Choc. Lab. - Lane's Cajun Sydney (Sydney) - will be 3 years old on the 26th of this month.- MudHog
- Post #33
- Forum: SuperDuty Community Lounge
-
M
joke time
PLEASE tell me you get it. -popcorn -popcorn- MudHog
- Post #3
- Forum: SuperDuty Community Lounge
-
M
Who is getting snow?
we got a few flakes that fell Monday night. To bad they melted on the way down to Earth, so all we got is rain.- MudHog
- Post #22
- Forum: SuperDuty Community Lounge
-
M
Door seal, Wind & Road noise Fix.
I did this to mine today. Hopeing it solves my squeaky rear doors. I did just the two back doors on mine. I used straight DAWN instead of mixing it with water. Ran a piece or wire all the way through to the opposite end. On the tube I cut a small hole about 4" from the end and fed the...- MudHog
- Post #5
- Forum: Do-It-Yourself Articles
-
M
Door seal, Wind & Road noise Fix.
I've been wanting to try this on my truck, but haven't got to it. Like the "Mother-Inlaws Daughter" classification.- MudHog
- Post #3
- Forum: Do-It-Yourself Articles
-
M
Scored big at the junkyard!
Careful with making your own tank. If you get in a wreck and the tank explodes and causes damage, you can and will be held responsible for it. Also make sure you psi test it after fabrication. Preferably filled with water and then pressured up. Otherwise, plain air would have to do and use...- MudHog
- Post #7
- Forum: SuperDuty Community Lounge
-
M
Range Sensor
There is a "Neutral CL (centerline)" mark on the new part. You put the shifter in neutral and remove the part. Install new part and shift back to park. Part number is: F7TZ-7F293-AA and it's called a "Range Sensor". Not a "Range Switch".- MudHog
- Post #3
- Forum: General Super Duty Discussion
-
M
Range Sensor
Just replaced my range sensor on my trans yesterday. Two bolts hold the part on and one electrical plug. I had an issue with my reverse lamps, but have heard that this part will cause a truck not to start as it is also the park and neutral switch that allows starting. Tells the computer where...- MudHog
- Thread
- Replies: 2
- Forum: General Super Duty Discussion
-
M
My wife wants a boat
I just sold my Lowrance LMS240 and upgraed to the Garmin GPSMAP 182. The Lowrance was a PITA to operate. I actually kept the manual on my boat so I can read it when I wanted to do something. The garmin is SOOOOOOOOOOOOOOOO nice. Mine is also internal antenna, so I don't have the mushroom on the...- MudHog
- Post #10
- Forum: SuperDuty Community Lounge
-
M
4X4 question
The transfer case is full time 4wd. The front shaft spins even in 2wd. The switch activates a vaccum pump and pulls a vaccum on the lines going to the hubs. This vaccum pulls a pin which engages the hub to the axle shaft, this giving the truck front wheel assist. The only time the x-case is used...- MudHog
- Post #7
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
M
Trans Cooler
To bring a topic back to life: I just finished going through cooler pains. My trans went out last Feb. Since then it has been rebuilt AGAIN. I brought it to a local shop for the work and was warrantied the 2nd time. Their rebuild only lasted 2600 miles. Stock trans lasted 76,000 miles...- MudHog
- Post #15
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
M
radiator coolant change
I wiped out wal-marts supply of distilled water when I bought my supplies to do the coolant flush. Daryl helped me in my yard. He was unbolting my water pump to change and I was draining the radiator for a flush and gold coolant swap over.- MudHog
- Post #13
- Forum: General Super Duty Discussion
