Recent content by Paul H

  1. P

    FOKISD March Spring Gathering

    -------------------------------------------------------------------------------- Ford Ohio Kentucky Indiana Super Duty club Spring Gathering March 14th All welcome dinner and greetings A chance to meet new and old friends FOKISD Event 2008
  2. P

    4th Turbo Replacement

    That was the original problems with the 6.0L. They were built and sat on lots untill sold. That is where the term LOT ROTT came from. Two things that will cause problems with the turbo. 1. Not driving (letting it set for a week or more) 2. Getting it hot and lots of black smoke from...
  3. P

    What is needed to service a 6.0 ?

    I hope you mean you got 15 quarts or was that 5 gallon?
  4. P

    Help Needed Ok I'm crying uncle on this one, need help.

    Fuel pressure will normally pulse like that due to being a diafram pump. It is not like running an electric where the pressure is constant. Will have to read back through your problem again and give it more thought. Ok so the truck ran fine till before the fuel canister was changed? Was it...
  5. P

    injector orings

    as long as the copper seal rings re-seat and seal , and you torque the hold downs correctly it should work for you. Make sure you lube them good going back in.
  6. P

    Question Running on 4 cylinders??

    If you have a shorted wire in the under cover connector , The IDM will shut that bank off to protect itself. So yess it will run on 4 (just one bank or the other but should also show a CEL
  7. P

    Help Needed Biodiesel blew 3 injectors

    The rough idle till warm and no power is common, my 04 does that and never had bio in it. It is due to the surface tention of the oil in the very tight tollerance spool valves on the injectors. once the oil warms up the spool valve can move freely. As to the bio, there have been a couple of...
  8. P

    Diagnostic programs for the laptop?

    Thanks guys
  9. P

    Help Needed Trip computer

    is this the over head display that does the milege? There is a over head display fix webpage out there. Check up in the 99 and up forum someone should have the link.
  10. P

    Diagnostic programs for the laptop?

    Ok guys I have a laptop I use on my 1996 7.3L I can do all the tests and even a dashboard and record. What do I do for the 2004 6.0L ? The program will not connect to the PCM nor communicated with anytrhing in the 04. Any Ideas?
  11. P

    CPS questions

    For all those who rum the Activator II trailer brake control, With the trailer connected the Activator II emits a signal when the brakes are applied. This signal travels all through the wire harness and will overcome a weak CPS signal. This confuses the PCM and it will shut down. Even at idel...
  12. P

    Help Needed Ok I'm crying uncle on this one, need help.

    I have seen 7.3L run as every day drivers on 4 PSI of fuel pressure. You want at least 70 psi at the check point at idel. Too much pressue would make the injectors hard to fire and retard injection. Also make sure the hoses to the fuel canister were reconnected the right way and that...
  13. P

    well finaly figured out whats wrong with my truck.

    Clean the cup good and make sure the surface where the copper seal washer should meet with has no pits in it. Stuff it with an injector and go.
  14. P

    Replacing my F350 badges

    While you are at it , Here ya go T 444E,  VT 365,  International Domed Label, badge
  15. P

    Turbo hose again

    The problem is not the hoses or clamps or tacky glue. The problem is the IC pipe on that side is not supported and when it shakes during throttle changes it is always pulling on the turbo boot. I was blowing mine off twice a week with just normal freeway driving. I took a small bungee cord...
See more

Members online

Total: 223 (members: 1, guests: 222)

Forum statistics

Threads
30,512
Messages
266,061
Members
14,625
Latest member
woodrow58

Latest posts

Top