Search results

  1. B

    No Start: High Pressure Oil Pump & Fitting Removal

    would be cool if you showed the part numbers as well ? thanks great vid
  2. B

    Question 08 6.4

    ok thanks , you must be the only one ? no other replies ?
  3. B

    Question 08 6.4

    ok , No offence , then why did you reply ?
  4. B

    Question 08 6.4

    my 08 6.4 , keeps giving code , P0088 ? I think it's related to the fpr ? and a P2080 ? as well , anyone have or had similar issue's ? thanks
  5. B

    No Start: 6.0L Powerstroke IPR Replacement

    My 06 ford van , is only getting 350 psi pressure at the icp cold and won't start , could the ipr be the issue ?
  6. B

    Question Slow coolant leak

    I have not done this personally , But if you remove the egr , and raise the back of the truck with a floor jack etc , if the erg cooler is leaking you should see coolant in the erg hole , you may have to leave it over night if it is a start of a egr cooler failure , ? if you see coolant in...
  7. B

    Question 1 and 3 injector

    I have the balance codes for 1 and 3 injectors , is it hard to change those 2 ?
  8. B

    6.4L No Crank EGT Sensor Codes

    took a couple of hours but got the broken end out , patience and good drill bits , back together works great , thanks for the vid
  9. B

    6.4L No Crank EGT Sensor Codes

    Great vid as always , but what if it is already broke off ? what's the best way to remove it ? I don't see how it can be drilled all the way through ? as it would damage the area for the probe to seal ?
  10. B

    Question 08 PS leak , ?

    found it , the front seal on the power steering pump was seeping , and it ran down and was dripping of the balancer , not to bad to change , getting the fan off was the biggest hassle
  11. B

    Question 08 PS leak , ?

    2008 f350 has a power steering leak ? it drips off the crank pulley ,? but I cannot locate where it is coming from ? anyone else had this same issue ?
  12. B

    Question Code question

    sorry it's a 05 , 250
  13. B

    Question Code question

    I have a reoccurring code PO277 ? search the forum and I did not find anything regarding that code ? what is the cause ? and is there a good solution ? thanks folks
  14. B

    Question 05 6L no start at all

    ok thanks , I don't remember that high of pressure just cranking it ? also is there a lift pump or fuel pump to supply the low side fuel
  15. B

    Question 05 6L no start at all

    thanks for all the feedback
  16. B

    Question 05 6L no start at all

    any one ??
  17. B

    Question 05 6L no start at all

    ok , so my 05 decided it will not start today , kicks like it wants to ? checked the codes , it has a crank sensor code , but I also noticed the icp pressure is really high ? 1680 psi at just cranking ? is the ipr bad as well ?
  18. B

    Question 2006 6L Hot Start issue

    been doing some research here , I am a little confused about HPOP failure symptoms ? can someone give some insight on this ? when the HPOP fails what are the issue's surrounding it ? poor cold start ? not running etc ?
  19. B

    Question 2006 6L Hot Start issue

    ok , just did a check on it , lots of pressure , at icp sensor 654 psi when cold starting , lots of pressure while driving , when it idles good pressure , just shut it off and tried to restart after 5 min only getting 350psi ish at the icp sensor ?
  20. B

    Question 2006 6L Hot Start issue

    Ok , so pulled 2 codes this morning , po335 crank position sensor , and P2291 low icp ? starts great when it's cold , but when at operating temp , if I shut it off sometimes it will not start for 10 min or so ? just cranks over , I am thinking the crank sensor has more to do with this then the...
  21. B

    RH Bank Fuel Injector Replacement In Detail

    Awesome vids , Very helpful
  22. B

    No Start: 6.0L Powerstroke IPR Replacement

    great vid
  23. B

    Question 2006 6L Hot Start issue

    ok , it's colder then hell here in Canada , last week my truck started with the no start when it's at operating temp ? no codes , and it's intermittent ? any idea's ?
  24. B

    Question 05 Transfer case unlocking

    thanks for the reply , somebody unlocked one front hub ? locked it in , been working for 3 hours no problem , thanks again
  25. B

    Question 05 Transfer case unlocking

    Ok ,my 2005 , the other day I was plowing snow and the transfer case went to 2 wd ? and stayed there , had it scanned out ,, dealer said dash switch was bad , put a new switch in today , plowed for about 40 min , same thing again ? went to 2wd ? now it's stuck in the snow bank !! any idea's...

Staff online

Members online

Total: 58 (members: 1, guests: 57)

Forum statistics

Threads
30,565
Messages
266,218
Members
14,690
Latest member
Daddydirt79

Latest posts

Top