Search results

  1. J

    97 F Superduty stops running

    Got the truck back this a. m. with a new ICP Sensor. Runs perfectly hot or cold but an expensive lesson. I had no idea where else to look. App. 1/2 of a boat dollar but it works. Thanks to all.:sweet J R
  2. J

    97 F Superduty stops running

    Faulty PCM ?? After a lot of checking the mechanic told me the communication is lost after the truck warms up, causing it to stall. When the truck cools down he can get readings with the scanner. I don't know enough to ask about the readings but has anyone seen or heard of this failure mode on...
  3. J

    97 F Superduty stops running

    I took the truck to these guys yesterday: Griffis Automotive Clinic - Automotive Repair and Service in Groveland, Florida He said he had another one in the bay with the same symptoms and in the past it has bad injectors. I'll post the results as well as the pain when I find out. Thanks for...
  4. J

    97 F Superduty stops running

    :rant And the saga continues. Replaced the CPS this A.M. with the new grey one and took her for a spin. Got her up to temp on the highway and stopped to fill the tanks, did not stop running at idle. After 10 or 12 minutes attempted to start the truck, SOS. The only thing I can do at this...
  5. J

    97 F Superduty stops running

    Fuel Pressure Screen I forgot to list that procedure. I used several q-tip sticks and WD 40 to clean the screen from inside the bowl. I kept at it until a q-tip came out spotless. I think the screen is clean. I hope all of this works and it isn't injector o-rings as I think that process may be...
  6. J

    97 F Superduty stops running

    IPR rebuilt Thanks guys for the advice on the IPR, I didn't have a clue about it. Found Viton O-Rings at NAPA, (no body had the kit in stock) and the unit has been removed, cleaned, replaced the rings and cleaned the connector. Used die-eletric grease on the connector body to try to inhibit...
  7. J

    97 F Superduty stops running

    Having a problem and I can't find the solution. My 97 DRW 7.3 Turbo, 5 spd. manual, starts fine, runs well for 30 minutes or so on highway and the stops when dropping to idle for a stop. Will crank very quickly, tach is responding but will not fire. Have fuel in the filter bowl, filter is new...
  8. J

    SuperDuty Tow & Transport Pics (What Are You Pulling Out There)

    Toy Hauler Here is my "Toy Hauler", 17,000# and 33' of her.:)
  9. J

    97 Superduty Fuel Consumption

    You are right on the GCVW. Cat scales had the rig at 24,607# before I filled the boat with gas. The truck only has 60,000 mile; just finished gauges, chip, 4" exhaust with 3" downtube and a DIY Fleetwood filter. Power isn't an issue, she runs like a scalded dog if you put your foot in it (sans...
  10. J

    97 Superduty Fuel Consumption

    My 97 Superduty is DRW 2 wheel drive, with a 5 speed manual tranny and 5.13 rear end. Have not weighed the tongue weght but estimate 1,100 # +/-. There have been a few ramps where the wheels would try to spin in granny with only idle RPMS. The other wheel would grab and so far, we have not had...
  11. J

    97 Superduty Fuel Consumption

    I don't know which rear end is on it and it is parked in the RV lot, not readily accessible. My fear with a taller ring gear would be pulling it up the ramps as I don't have 4 wheel drive and the boat is really heavy. This would require a locker or some type of limited slip which together would...
  12. J

    97 Superduty Fuel Consumption

    We have about 3,000 miles pulling a 16,000+# boat and trailer and the last trip I was able to get a decent estimate of 7 MPG. This truck has the 5.13 rear end and a 5 speed manual tranny and the RPMS are close to 2500 at 57 MPH which I chose as a normal cruising speed. My question is ...
  13. J

    How to pull the side fuel tank

    Side tank :)I dropped the tank with a transmission jack with the lines attached. Disconnects must be frozen. Repairs made and truck is on the road again. Thanks.
  14. J

    How to pull the side fuel tank

    This has to fall under the 'Dumb a**' category. I was drilling a hole in the frame on the drivers side and popped a hole in one of the fuel lines. Needless to say there is fuel going everywhere and I can't get the lines loose from the sidriver's side tankl where the lines are hidden behind...
  15. J

    97 7.3 will not start

    Finaaly got it running!! :innocent:)Thanks for the suggestions. After checking all of the connectors, fuses, termination points, etc. I pulled the parking brake assemby and found the edge connector of the chip was about 1/2 pulled loose ( I'm guessing from my awkward attempts at removing dash)...
  16. J

    97 7.3 will not start

    1997 7.3 Won't start Is there a wiring diagram on line someplace for this 97 Superduty??
  17. J

    97 7.3 will not start

    Checked all fuses with meter and found no problems. Is it possible while moving wires around under the dash I screwed something up? I have tried moving everything around again, checking connections but that hasn't fixed it. There has to be a common denominater but I'm not smart enough to know...
  18. J

    97 7.3 will not start

    97 Superduty cranks but won't start. No WTS or other warning lights. I was trying to find a 12v key on source and possibly pulled something loose but I can't seem to find anything. Both batteries unhooked and 12.55 - 12 65 v with clean connections. All fuses look good. Anyone have an idea where...
  19. J

    Newbie from central Florida

    Next project will be greasing all of the Zirk fittings everywhere but especially the drive shaft universals. Already have the 85/140 gear lube for the differential. Found the article on pulling rear cover with all of the details. Hopefully I can catch the old lube in a big bucket. ?? How...
  20. J

    Newbie from central Florida

    Okay guys, EGT and Boost gauges installed and working well. (Autometer) New WIX air filter installed with a short piece of 4" tubing. Replaced a nasty looking fuel/water filter after cleaning the bowl (this may have been the first time. (broke the old cover getting it off) Installed the 6...
  21. J

    50 Gallon Fuel Tank

    Auxiliary tank not legal?? Now that poses another problem. After reading several articles about the DOT process and auxiliary tanks, this set up on my truck is illegal. Does anyone else have a similar set up on their truck?? ( I won't tell):sly Who knows how long it has been on there and...
  22. J

    Newbie from central Florida

    I'm convinced on the gauges before chipping; what is the favorite brand for EGT and Boost?? Is there a big difference in quality?? Best suppliers??
  23. J

    50 Gallon Fuel Tank

    Venting Auxilary Tank Since I just bought the fill cap, I'll see if there is a way to run a small hose to the canister (after I find its location). Thanks Dave
  24. J

    50 Gallon Fuel Tank

    You are right, the aux tank on the deck is filled from the top and I do have 3 tanks. I don't know if the cap (new) is vented or not, I'll have to look. Thanks
  25. J

    50 Gallon Fuel Tank

    Next question concerns a 50 Gallon Auxilary tank monuted on the bed. It has a ball valve with a line connected to the Fill housing. I don't know if it is blocked or if both tanks have to be vented, but it will not fill the side tank. The last picture is on top of of the tank and may be a...

Members online

Total: 82 (members: 2, guests: 80)

Forum statistics

Threads
30,516
Messages
266,069
Members
14,627
Latest member
castellscl

Latest posts

Top