Search results

  1. T

    Motor mount

    I have a noise when in drive & taking off, it sounds like the motor mount rubber is gone & it is hitting a metal stop of some kind. It also sounds like some metal to metal vibration while driving. Can the motor mount loose the cusion& still stop the motor from rolling?:dunno
  2. T

    Oil in the fuel?

    I have been reading about the Cummins folks putting waste motor oil in the fuel. Can we do this to a 7.3 Ford , without damaging anything???:stir
  3. T

    mirror

    Dose any one know of a cheep place to get a LH tow mirror, I lost mine this morning = too close & the Chevy lost his too.
  4. T

    Question Pop noise

    I have a loud pop with light pedal. It sounds like a U joint But I can put it in reverse & back in drive & won`t pop. Is there a part in the transfer case that would do this ? Or the stub shaft splines in the trany? Just trying to see what it is before it strands me.
  5. T

    Question 4x4

    I have no vaccume at the hoses ( wheels ), where is the next place to look for a leak or something broke??? The transfer case works & putting the hubs in manual got me out of the ditch.
  6. T

    Springs

    My plastic pads that go between the front springs are wore out . What should I put between the springs to get rid of the metal grinding?
  7. T

    Question Oil leak??

    I just found a loose hpo hose going to the driver side of the block. What is needed to repair the leak & could this leak let air into the oil to caues a ( miss ) ? I tightened the line & it will still wiggle ?? Yea I need some help on a Sunday afternoon. Also how do you get to the turbo...
  8. T

    Question In tank

    A buddy just told me that there are 2 fuel filters in the tank. His truck is a 2002 & my truck is a early 1999. Do I have a filter inside my tank ???
  9. T

    Brakes!!

    I keep getting the rotors too hot & warping them.I need to know what type rotors to replace the stock ones with. Cross drilled , frozen ??? I know I will get lots of advice, Thanks in advance. T.Tolle
  10. T

    Map sensor

    I have forgot what the MAP sensor is & what it does. Is there a mod to fool the computer?? My truck bypasses boost when changing gears, am I headed the right direction?? T.Tolle:dunno
  11. T

    Question Camshaft float?

    Has anyone had camshaft float?? My truck misses, runs , misses, runs. I have heard that the camshaft can wear a plate & move to the rear of the block, & the cps looses the signal . Have you had this problem & how do you check how much the shaft is moving -(the gear has lobes on it ). Anyone know...
  12. T

    Camshaft Timming???

    Camshaft Timing??? Has anyone ever had a problem with the gear on the camshaft moving? I have heard that the pulley is pressed on the shaft ( Dave at Swamps ) & it can loose it`s fit & start moving front to back , (floating -Jodey @ DP ). If you have had this problem what was the fix??? I...
  13. T

    Help Needed Idm ???

    How do you tell if the IDM is good or bad?? I have mine out & this truck has ben missing irradically Thanks T.T.
  14. T

    Question Why ?? is my truck running poor?

    I have a intermittent miss that is worse with a heavy dew. I have put in new injectors $$, new torque converter $$. This problem is at low rpm & little throttle about 2 to 5 psi boost. I think there is a module under the left fender that converts 12 volts to 140 volts dc could it be at fault...
  15. T

    Help Needed Low boost miss

    :dunnoI have a low (1 to 6 psi )boost miss. The fuel pressure is at 64- foot on the floor. Take the oil cap off & steady small stream of blow by.Miss gets worse with chip HP increase. Just put new injectors in to solve the problem. Can this be a computer problem - wiring or is this the $$...
  16. T

    Help Needed Injector trouble

    HELP !! I have been having a rough running truck today & just heard a hard knock in the right bank. I think it is an injector. Is there something I can do other than replacing it?? I am planning on leaving on about 800 mile trip Sunday.Help & Thanks as usual to all.:hail
  17. T

    Question Hot water

    I rember reading about a valve that turns off the hot water so the vent air is cooler, anyone know where to find the write-up?:dunno
  18. T

    DP tuner VS Six gun

    Hi I have a Banks 6 gun now that I run in # 2 position. I get about 14 - 15 mpg, not pushing it. What can I expect (real world) if I change to the DP tuner? I would like to hear from 7.3 owners. My truck has 145k on it & I have never gotten better than 16 mpg. At $4.00+ a gallon it is getting...
  19. T

    Viton 0 rings

    I have been having a problem with my bowl drain leaking. Long story - short I found Viton 0 rings at Autozone in a kit PN# 80020, about $7.50. Now I'm ready for Bio-diesel.:thumbs
  20. T

    Fuel leak

    I have fuel leaking out of the drain pipe,will the new 0 rings stop this leak or do I need to spend $65 at Ford? I have the drain valve off now. :thanks
  21. T

    Fuel loss

    Hi I have been on the side a long time just reading & learning:hail :hail , now I have fuel leaking from the bowl drain. I don't know if the O-rings are bad or if water froze in the yellow plastic drain. Where can I pick up the 0 rings & how does the drain valve come out? Thanks in advance for...

Members online

No members online now.
Total: 28 (members: 0, guests: 28)

Forum statistics

Threads
30,517
Messages
266,070
Members
14,629
Latest member
Colvinecoboost14

Latest posts

Top