Search results
-
B
Door Ajar Light???????
Here are the Facts: 2003 F250 Crewcab 6.0 1.Door ajar light will not go out 2.Doors will not auto lock when shifted into drive. 3.Cab lights will not go out by turning the key to ON.(Yes I have checked the dimmer switch) 3. Cab lights will eventually go out once above ~10mph/1500rpm...- bserventi
- Thread
- Replies: 28
- Forum: General Super Duty Discussion
-
B
Upper Rear Shock mount/nut stripped
I am trying to replace the shocks on my 03 f 250. I got all of them done except the right rear. If you look at the rear shock, the lower part of the shock has a bolt and nut that go through two tabs and the shock. The upper part of the shock mounts over a stud and is held in place with a nut...- bserventi
- Thread
- Replies: 2
- Forum: Tires, Wheels, Suspension & Accessories
-
B
Carrier Bearing and U joint Install Questions
I need to replace the carrier bearing on my rear driveshaft. While I had it apart I was also going to replace the U joints as well. I'm not worried about swaping the U joints, I've done the front axle U joints with out problems, I would imagine the rears would be the same. My concern is...- bserventi
- Thread
- Replies: 15
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
B
Questions about installing new hub?
My ESOF was not holding a vaccum, so I replaced the knuckle seal and yellow oring. While I was at it I also replaced the U joint, outer axle and hub. I've been reading tons of posts and looking at tons of pictures of how this is performed. It all seems to have gone back together great. Holds...- bserventi
- Thread
- Replies: 4
- Forum: 6.0L PowerStroke Engine & Drivetrain
-
B
Hub Seals
My ESOF will not engage the 4x4. I have traced all the vacuum lines and isolated the the problem to the drivers side hub. From what I've searched it seems like the hub seal is what needs to be replaced. What is the correct part number of this seal? Is it a easy fix or are special tools...- bserventi
- Thread
- Replies: 6
- Forum: 6.0L PowerStroke Engine & Drivetrain
