Lodibob
SDD Junior Member
Hello and i thank any and all who respond in advance. My 2006 f250 6.0 has a hot no start. I have done updated stc fitting, stand pipes, dummy plugs, ball tubes, and injector orings top to bottom. Fires up quick when cold but will not climb above 300 psi icp when hot cranking. Ipr goes straight to 84.7 at wot. Hot idle is 580 psi. Sometimes ipr goes to 84.7 at idle then gas it a little and it comes within normal range. Once in awhile it stalls at stop light because icp drops below 500 psi. Then will not start til eot is around 150f degrees or less. Sometimes sooner if i through ether at her but i have only done that in emergency. Thank anybody with help in this matter.
P. S.
I use scanguage 2 and have auto enginuity with ford bundle also.
P. S.
I use scanguage 2 and have auto enginuity with ford bundle also.