hheynow
Señor Aceite de Soja
My gauges were installed a few days ago and yesterday I noticed an ATF drip from the tranny sender. I removed it and wrapped some teflon tape to seal it and now it's fine. Then I saw this on egauges.com.
My tranny gauge is electrical. What should I do?
Should I use sealant or Teflon tape on the threads of my sender?
Do not use sealant (including Teflon tape or plumbers pipe dope) on the threads of temperature or pressure senders. This will not allow the sender to properly ground itself to the engine and will cause the temperature to register high and the pressure to register low. This does not include floating ground senders which include a second terminal specifically for grounding.
My tranny gauge is electrical. What should I do?
Last edited: