SeventyMach1
Full Access Member
I need to drive this tomorrow ... so yeah ... emergency, lol.
I am trying to remove the parking brake assembly so I can see if the cable is broken. I have to get the beast inspected tomorrow. It popped on me the other day & no longer works. I am going to see if the cable is broken.
So apparently I have to remove the PCM to get to one of the bolts (up top). Under the hood, I loosened the 10mm bolt and slid the connector off. Inside the truck, I took the 2 little bolts out that hold the puter to the bracket. The PCM is not sliding out ... like something is still holding it in. What do I need to do from here?
Edit: I notice the black casing around the puter had a tab (the whole length of the left side). I can't figure out how to get it to release. And thank you Mr. Chilton for putting that part in the damn manual!
I am trying to remove the parking brake assembly so I can see if the cable is broken. I have to get the beast inspected tomorrow. It popped on me the other day & no longer works. I am going to see if the cable is broken.
So apparently I have to remove the PCM to get to one of the bolts (up top). Under the hood, I loosened the 10mm bolt and slid the connector off. Inside the truck, I took the 2 little bolts out that hold the puter to the bracket. The PCM is not sliding out ... like something is still holding it in. What do I need to do from here?
Edit: I notice the black casing around the puter had a tab (the whole length of the left side). I can't figure out how to get it to release. And thank you Mr. Chilton for putting that part in the damn manual!
Last edited: