tubzz
Full Access Member
wife went out and started here truck this morning.it had a slight shake to it.when she got to the black top and took off.the truck started shaking about 1500 to 2000 rpm.had know prower.i drove it tonight and on the low end it feels alright.but when you get going it does have a shack and has no power.i hit this hill at 70mph and at the top i was down to 40mph (about 1/4 mile hill empty).she said the truck ran fine when she park it.i check all the outside VC plugs looked fine,check fuel pressure (62 psi)
it doesn't have a missed or coughs just runs flat.kinda like a old chevy with a stuck choke.
the EBPV and cat have been gutted so these are ruled out.i did GP and replace one VCG,under VC harness,and one outside VC plug and pins 2 weaks ago so they should fine but will check them again.
what else can i check?or has anybody have this happen?we (me and the wife) do all are work on the trucks and never run across this.some idea would be helpful..i only have a SCMT for code reading and no codes are on it.i hope this make sence,just hard to put it to words what it doing.

it doesn't have a missed or coughs just runs flat.kinda like a old chevy with a stuck choke.
the EBPV and cat have been gutted so these are ruled out.i did GP and replace one VCG,under VC harness,and one outside VC plug and pins 2 weaks ago so they should fine but will check them again.
what else can i check?or has anybody have this happen?we (me and the wife) do all are work on the trucks and never run across this.some idea would be helpful..i only have a SCMT for code reading and no codes are on it.i hope this make sence,just hard to put it to words what it doing.
