You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Search results
-
F
Hutch mod. Let's bat this around a bit.
After I posted it, did some more research, I realized I knuckleheaded that one hard. Didn't read up carefully enough, mis read, mis understood and just flat missed up. I was going to post back but thought I would just slip back into the wood work and be quiet. Did futher research and found that...- FoMoCo
- Post #5
- Forum: 7.3L PowerStroke Power & Performance
-
F
i got my new banks ram-air intake today
Well, as I was reading the posts someone mentioned the ais filter from ford with donaldson filter technology. I've not been scanning the site for a while and hadn't heard of the Banks unit until yesterday and it peaked my interest. It seems as though most of these other filter systems use a...- FoMoCo
- Post #37
- Forum: 6.0L PowerStroke Power & Performance
-
F
i got my new banks ram-air intake today
Oh, I must add to above post. Given the environments that I am in from time to time I wouldn't run a cotton element. If I were running around on the street I might consider it. Then again, you never know when something beyond you contol will happen. For the record, the AIS is a real clean and...- FoMoCo
- Post #35
- Forum: 6.0L PowerStroke Power & Performance
-
F
i got my new banks ram-air intake today
Over the last weekend I finally changed out the turbo. Previous posts I had dusted the turbo in nasty silt beds in Nevada running chase for the Vegas to Reno off road race. I was running the K&N flat pannel replacement filter for the 7.3. That filter let so much crap past it, it was disgusting...- FoMoCo
- Post #34
- Forum: 6.0L PowerStroke Power & Performance
-
F
Roll Call!!!
Are the Corn Flakes any fresher that close to the plant? LOL- FoMoCo
- Post #12
- Forum: Northwest Area
-
F
Hutch mod. Let's bat this around a bit.
Alright, I've been mulling this one over. I see a few flaws in the installation and the kit from itp. Ok, first problem is the #8 starvation problem, Feeding from the rear helps that. Second issue is the air in the line and evacuating that to "prolong injector life". What I see is that the...- FoMoCo
- Thread
- Replies: 4
- Forum: 7.3L PowerStroke Power & Performance
-
F
CB radio & antenna mounting
I will when I'm done, Being the procastonator that I am don't look for it in the next few weeks though. :roflmao I use the V8000 (moded) predominately for Baja 500 and 1000 chase. Can you access the Dallas reflector on channel 3? Dallas Reflector is 945 channel 3 (9453) ties into our winsystem...- FoMoCo
- Post #17
- Forum: Mobile Audio/Video & Electronics
-
F
Fuel Bowl problem
Ok, we'll let you slide on that one. Dow Corning does make a great silicone grease that I use quite a bit. Holds up to 400+ degrees, impervious to petroleum as a matter of fact you almost can't get it off of something if you want to. :roflmao great for orings, packings etc. Very much different...- FoMoCo
- Post #7
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
F
Bullydog disappointment
Oh and by the by. MBRP went up and was done in under an hour after getting the old one out and did it by myself. :thumbs Took a little ingenuity though on the downpipe.:D- FoMoCo
- Post #26
- Forum: 7.3L PowerStroke Power & Performance
-
F
Bullydog disappointment
Um.....errr........well ........have you ever noticed moisture from your exhaust. Condensation is a byproduct of combustion for most fuels let alone that as the exhaust cools it can and will draw outside air into your exhaust system and in high humidity areas that will be moist air which will...- FoMoCo
- Post #25
- Forum: 7.3L PowerStroke Power & Performance
-
F
Fuel Bowl problem
Silicone paste:dunno Silicone doesn't hold up to petroleum based procucts. Good mil. spec teflon does though.:thumbs- FoMoCo
- Post #5
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain
-
F
CB radio & antenna mounting
I stuggled with this one for quite a while. Knowing the best location and bringing yourself to doing it are two different things. CB radios and Amateur radio equipment is two entirely different animals though. I run a Kenwood 742 on 2m, 1.25m and 70 cm with 60w, 30w, and 38w and an Icom V8000...- FoMoCo
- Post #7
- Forum: Mobile Audio/Video & Electronics
-
F
Impeller question?
Hello guys, haven't been around as everything was hunky dorey until........I was running chase for the Vegas to Reno off road race. To get to pit two I had to go through some of the nastiest Nevada silt I've ever seen. -mad 12 to 24" deep and 20 feet to 100 yds. long. It looked as though I was...- FoMoCo
- Thread
- Replies: 3
- Forum: 99+ 7.3L PowerStroke Engine & Drivetrain