Scar13
Full Access Member
Where are the intructsion on straight piping?
the part that I rotate 180 degrees has little bungs on it?
the part that I rotate 180 degrees has little bungs on it?
Where are the directions on straight piping?
- Thread starter Scar13
- Start date
Ford_Forgotton
Full Access Member
I just cut the center out of my muffler and welded in a straight section at an angle. This way I kept all my hangers.
CHPMustang
Senior Member
Trey,the section you rotate 180 degrees is the inlet tubing that went into the muffler,I hope that answers your question a little better
Bill
Bill
Scar13
Full Access Member
got it done last night!!! WOW! Sounds great!!
CHPMustang
Senior Member
Coming over to Brett's Saturday there Scar so I can check out the new sounds?
ryaneverk2
Full Access Member
Haha, amazing how great it sounds with just a simple muffler delete, no?
Scar13
Full Access Member
Bill, yeah is it still on or did it get pushed back?
Ford_Forgotton
Full Access Member
I always thought my straight pipe sounded pretty bada$$, but now that I have my full 4" exhaust with flow thru muffler, I have to admit, the truck does sound even better.
Plus, I didnt realize how much DRONE was in the cab until the new muffler went on. The truck wasnt any LOUDER inside, but something about the straight pipe gave the cab a slight hum that is now gone with the flow thru muffler.
Can still here the whistle tho, and thats all thats important.
Plus, I didnt realize how much DRONE was in the cab until the new muffler went on. The truck wasnt any LOUDER inside, but something about the straight pipe gave the cab a slight hum that is now gone with the flow thru muffler.
Can still here the whistle tho, and thats all thats important.
