I have a '02 Crew cab and the turn signal will not return after a right hand turn but will return from a left hand turn . Will it be the turn/wiper switch or is there a return cam on the steering column shaft??
I would appreciate any insight.
Thanks, Duane
Anyone out there have the new Edge Evolution? Looking for some insite on programers before I purchase one. Not wanting a race truck just a little pep and milage if Ican keep my foot out of it.:D
Does anyone know the amount of tourqe increase from a programmer is at which I will need to consider an upgrade on the automatic transmission???
Stock 02 7.3, 4" mbrp, stock trans :dunno
block or no block
I would like someone to explain to me the difference between using a block to raise the rear of a truck and not to use it on the front. I believe you don’t want to have a lot of block there because of the torsion load when turning and having all the engine weight up front...
Springs
I have a one inch block that I machined up for the front of my '02. I have been running it for three years now. I don't see a problem with using a minial sized block on the front?:dunno
How do you check for a weak battery on the two battery starting system? Or do you replace both batteries when the cranking power gets a litle weak?:dunno
Are you sure you neeed 2"? use a floorjack to raise te front or the truck.
Measure before and raise the truck the 2" and step back to see if it is what you are looking for.
I only put a 1" block on my truck to level it.
I would be more worried about the track bar than the u-joints if you only...
I gutted one of these at the shop. I think you could find the bearing, but the race is the actual hub mount. So there is no way to get a new race. R-R is the most least expensive. Dyna-trac has the big $$$ replacement.
The Timken bearing is preset on the bearing load and grease.
Duane