TG I'll keep you in mind if they start looking for mechanics here at boeing in St. louis building F-18s and F-15s if you would like to move a little south.
done any front end work lately I would suspect seals also because it worked one day and didn't the next. If a hose leaks its not going to be intermitent.
as have also. I used to do furnace check ups at a crematory, I opened a cabinet and in a coffee can were all these "parts" wasn't expecting that. They are not as large as one would think.
You have to have ford enhanced software to read the trucks.
did you try pluging it in first? better = likely glow plug
check oil level? how long on oil change ? mine starts acting up with old oil and cold.
sounds like you just need to do some more reading and it will all become clear. as you educate yourself to the pros and cons of both. each have good points and bad, educate yourself then make decision.And don't count out DYI for either project. my biodiesel processor cost me less than 500.US to...
been there done that too. I did hvac had a little smaller rollaway in the service trailer opened side door and out falls all kinds of crap rolling down the street.
if you take it easy on the clutch it will dry out after a fuel leak been there done that takes about 1500 miles or so. I got 130*** on orig. clutch and now I'm flirting with 250***.
how many miles? I'll guess 120*** springs come out of the disc and at that point you need a new clutch when it happened to me I went with the LUK and love it lighter pedal with higher clamp load.And to save your question you do not have dual mass flywheel!
Above post might be correct but I...