Recent content by rynarnell

  1. rynarnell

    need help

    could always run on WVO....
  2. rynarnell

    Running rough

    DTC P1211. i got this code on my 94 7.3. I changed the fuel pump before the SES light came on because it was leaking out the weep port. Ran good for a while untill i started it one mornind it sounded like it was running on 4 cyl. When it warms up its a lot beeter but still not perfect. I just...
  3. rynarnell

    what 2 look 4?

    ya i baught the blue one with 83000 miles. Ive been driving it from wasilla to anchorage everday. and its running great.
  4. rynarnell

    what 2 look 4?

    theres another one thats the exact same but red with 63000 miles. Just had some more dents than the one that i baught.
  5. rynarnell

    what 2 look 4?

    im lookin at buying a 97 7.3 with 83000 miles. I drove it last night. Started right up in the cold and shifted fine. What else should i look for on these trucks? Thanks
  6. rynarnell

    EGT's question

    ok, thanks for you help
  7. rynarnell

    EGT's question

    At about 70mph im at 900' F pre turbo. I think my rpm's are around 1800rpm. Cause im still running stock 3.73 gears on 38" tires. If i regeared my truck to around 4.56. Thats supposed to get it close to stock power curve. Will that bring down my EGT's a little?
  8. rynarnell

    Whinning noise 06 superduty

    id say carrier bearing, or the pinion gear bearing isnt preloaded right.
  9. rynarnell

    Deeper Tranny Pans????

    I have the PML pan. It's the best cause it doesnt retain the heat like powder coated ones. And my temp has never gone above 160'F
  10. rynarnell

    Its 50 but starts like 25?

    i thought the 6.0's had Baro temp sensors...
  11. rynarnell

    thermocoupler install

    funny, i just got my gauges from diesel manor too. you dont need to remove the manifold. Just drill a small hole on the rear of the drivers side manifold up from the bottom. So shavings will fall. go up one bit size at a time to make shavings small. Then vacuume it out. then put the tip of the...
  12. rynarnell

    Diesel/Powerslot dealer shops in Oregon?

    try XTC trucks in Hood River Oregon. Hes a cool guy and will help you out.
  13. rynarnell

    bushwacker flares

    Has anyone powder coated or Sprayed the Fender flares with bed liner? I saw a truck with bushwacker fender flares that looked like they were sprayed with rhino or linx. Just wondering if anyone has done it and what they thought?
  14. rynarnell

    08 diff cover?

    well i just put on my cover. got some new bolts and used black RTV. Looks a lot better than the old rusty cover. It only took 3 quarts. So i have an 18 dollar quart of 75/140 synthetic left over.
  15. rynarnell

    Overhead Console

    me too!
See more

Members online

No members online now.
Total: 220 (members: 0, guests: 220)

Forum statistics

Threads
30,512
Messages
266,061
Members
14,625
Latest member
woodrow58

Latest posts

Top