Search results

  1. A

    AC kicks on and off

    the a/c clutch is probly slipping at higher rpms, you can remove a shim or 2 to buy you some time. i have been running my 99 that way for 2-3 years that way now. my problem was the a/c would work great at start up ,but would quite working when you drove it.
  2. A

    Help Needed 99 F250 auto transmission noise?

    were did you find a $200 converter at?
  3. A

    Newbie Hello

    Hello, I agree, the only one of the "BIG 3" not under communist control! Welcome to SDD :usa
  4. A

    Glowplug troubleshooting help?!

    Yes, and your silver 92 did not have glow plugs either.
  5. A

    Glowplug troubleshooting help?!

    X2 on batterys,starter could be weak also. i replaced good batterys before just to find the starter was weak. you are hearing your vacum pump running. never gas your fuel in an engine that has glow plugs in the combustion chamber, can end up with same results as using ether BAD.
  6. A

    Need real mirrors

    check out your local truck bone yard for an f650 for the mirrors and cover peices. looking around for some my self. can get the power and heated also.
  7. A

    lopey idle?

    do you unplug the injectors while the motor is running? or restart after un pluging the injector?
  8. A

    What size is the best?

    You will want the 1000 amp at least,better yet I have seen them up to 1500-1800 amp also.1 of your batterys are at least 800 amps and it take 2 to start your truck. just my $.02
  9. A

    lopey idle?

    My 99 does the same thing.It idles fine cold then when its warm it lopes like a gasser with a radical cam in it. Power seems fine,throttles up quick too,just lopes at idle.Would like to hear what others might think also.:dunno
  10. A

    03 7.3 E350 box truck can i use starting fluid?

    never use either or starting fluid on an engine has an electiric heating device-air box heater glow plugs or intake heater the results can be very exspensive. just fix the heating problem your engine will love you for it.
  11. A

    Direction involving tuner and gauges...

    only problem with deleting key holes, did you ever drop you keys in water or had dead batterys? pain to get into with no power in truck or key fob not working. just my $.02
  12. A

    More Turbo Whine?

    It is there to keep the cooled from heating back up.
  13. A

    More Turbo Whine?

    removing the insulation on the cold side of the after cooler would actually decrease your milage and power slighty. its there to keep the air that just went through your after cooler from being warmed back up from the heat from the engine be for it goes in to the intake for a more dense intake air.
  14. A

    More Turbo Whine?

    I dont think it would be helpful to remove the insulation, it's there to help get more dense air to make your engine more effiecent. Just my $.02
  15. A

    vacuum source on 7.3 for Hydrogen cell install

    Instead of using a pump I was thinking fo using a low flow regulator set at about 4 to 6 oz's tapped off of the intake. it wouldn't really affect the boost pressure at all.
  16. A

    vacuum source on 7.3 for Hydrogen cell install

    I'm setting up a 6 cell generator for a 99 7.3 psd and am planning on tee'ing off the filter restriction guage for my vacuum. Just my idea. Ihave a freind using a hho generator on a chevy 350 and went from 9.5 to 16 mpg's I hope to get as close as i can to his percentages as i can...Bud;tu
  17. A

    Hydrogen generator?

    I have a buddy running a 1 cell generator on an 85 chevy k30 dually 4.10 gears. He was getting 9.5 mpg and increased to 16 mpg on a 350 4v. Iwant totry a 6 cell on a 99 7. psd. If I can duplicate his resalts I should get about 25 to 28 mpg's.
  18. A

    Flexplates keep breaking on my 99 PSD

    I would replace your crank damper with a fluid damper. Sounds like it could be bad. We replace them on c13 c15 cats at 500,000 miles,have seen a bad damper break a crank. Just my thoughts...Bud
  19. A

    comment Top up your TANKS !

    Bio Diesel you by at the pump is made of new oils not waste oils. ADM is one of the biggest producers of B100. Made of 100% new oils....Just my $.02:CRAZY Bud
  20. A

    PowerStroke Diesel Being Replaced By?

    Tell me about it, I drive a 06 kw with a 435 C13 Cat and it has it share of problems,mostly valve actuaters. The shop has a Cat tech coming in every evenning working on them at our shop Mon - Fri.

Members online

No members online now.
Total: 147 (members: 0, guests: 147)

Forum statistics

Threads
30,516
Messages
266,068
Members
14,627
Latest member
castellscl

Latest posts

Top