Recent content by action4478

  1. action4478

    Transmission fluid flush pays

    From Mark Kovalski (trans engineer ): I've done this alone. It's easier with a second person, and sometimes helps prevent spills. 1. Things you need to get started: a. The transmission system holds almost 18 quarts of ATF, and you must waste a couple of quarts to be sure you get it all...
  2. action4478

    Help Needed Jumping tach at startup? Not the CPS!

    So that's the Mercedes you were telling me about ... Running veggie in it too?...
  3. action4478

    Help Needed 2001 HPOP reservoir dry

    There is some good reading on the subject ...click here... Scroll down to 5) or so ... Injector O rings can cause a leakdown over night also ... oil system pic, here...
  4. action4478

    Help Needed Ok I'm crying uncle on this one, need help.

    Have you tried running it with the MAP sensor unplugged ?....
  5. action4478

    The Official Zoodad Mod Sticky Thread

    Or .....this....
  6. action4478

    The Official Zoodad Mod Sticky Thread

    This is the one ....clicky....
  7. action4478

    BlueMule broken down in Albuquerque, New Mexico

    This from Racer_X ....: Excess resistance in the circuit is what causes it to burn the harness. Wiring is to small to handle the heat when the plug doesn't use the amps up to heat the tip. Heres a simple explanation: Ford/Nav VC gasket/harness was redesigned with better conductors several...
  8. action4478

    Won't start

    Another freebe , unhook the ICP connector & try to start it ,,, PCM defaults to 724 ICP pressure , may help start...
  9. action4478

    new member intro/seeking diagnostic help

    You are going to have to put this on a scanner & get some real time data,,, other than that its a guess on the codes ,,what you described I have only heard of once before,, If It happens every time , it may be in the filter,,,Get the codes if you can & go from there....
  10. action4478

    new member intro/seeking diagnostic help

    You may be getting a code 1212, ICP above desired...I would start looking for a plugged up edge filter....
  11. action4478

    TRUCK WON'T START

    Try running a lighter oil.. My wag would be the injectors are using the oil in the Resevoir, faster than the LPOP can work the colder , heavier oil... Some reading on the subject...Click me Scroll down to # 5 it talks about the LPOP....
  12. action4478

    EARLY 99 NO START

    Unplug the fuel heater or repair or replace it....It will happen again,,,,,,,
  13. action4478

    Won't idle after warm up

    IPR instructions ....here.... If you take it apart, ignore the pic of the wrench on the threads, It goes on the small barrel... Are you sure that an injector o ring didn't get nicked during install?
  14. action4478

    Instrument Cluster

    I would be looking at the wiring to the speed sensor......
  15. action4478

    EARLY 99 NO START

    May be the fuel heater ,,, fuse # 30 .. unplug the heater....
See more

Members online

No members online now.
Total: 157 (members: 0, guests: 157)

Forum statistics

Threads
30,513
Messages
266,063
Members
14,626
Latest member
jarrburg

Latest posts

Top